Page 2
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOULD ALWAYS BE OBSERVED, SHOCK OR INJURY: INCLUDING THE FOLLOWING: GENERAL ELECTRICAL SAFETY: READ ALL INSTRUCTIONS BEFORE USING 1. Unplug from electrical outlet when not in use YOUR SHARK NAVIGATOR LIFT-AWAY ® ™ ® and before servicing.
Page 3
HOSE ATTACHMENTS: DUST CUP/FILTERS/ACCESSORIES: 1. DO NOT use if air flow is restricted; if the air Before turning on the vacuum: paths, the hose, or the accessories become 1. Make sure that all filters are thoroughly dry blocked, turn the vacuum cleaner off. Remove after routine cleaning.
Page 4
This manual covers model number: NV352Q 31 TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz Watts: 1200W Amps:...
Contents Thank you for Getting Started purchasing Mode 1: Upright Vac the Shark ® Mode 2: Detachable Canister Navigator ™ Above-Floor Cleaning Lift-Away ® Storing Maintenance Emptying the Dust Cup Cleaning the Pre-Motor Filters Cleaning the Post-Motor HEPA Filter Cleaning the Turbo Brush...
Getting Started Fig. 1 Fig. 2 Fig. 3 Fig. 4 ACCESSORIES: CREVICE TOOL Reach deep into narrow spaces and clean between cushions, under radiators and baseboards and in FIRST THING’S FIRST, YOU NEED TO KNOW hard to reach crevices and corners. (Fig. 1) WHAT’S IN THE BOX YOU JUST OPENED: DUSTING BRUSH Hose...
Page 7
Your new Shark Navigator Lift-Away vacuum cleaner can easily be configured into different ® ™ ® cleaning modes to meet all your cleaning needs: upright vacuum and detachable canister - both with constant suction power. Fig. 5 Fig. 6 MODES:...
Mode 1: Upright Vac To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes. WARNING: The On/Off switch is on the top of the detachable canister. Always ensure the power is OFF (“O”...
Page 9
Cord Suction Hook Release Collar Release suction for easier push & pull on high pile carpets and area rugs. Fig. 10 Fig. 11 TO USE: ently press the floor nozzle down with your foot while you grasp the handle and tilt it back towards Rotate the cord release to quickly release the you.
Mode 2: Detachable Canister You can carry your vacuum cleaner in both modes by the carry handle located on top of the dust cup. Fig. 13 Fig. 12 LIFT AWAY DETACHABLE CANISTER FOR Attach desired accessory onto the end of either PORTABLE CLEANING ndle.
Above-Floor Cleaning Release suction for easier push & pull on high pile Fig. 14 Suction carpets and area Release Collar rugs. CLEAN ABOVE THE FLOOR IN UPRIGHT VAC OR Press the On/Off switch to the “I” position to turn the vacuum on for above-floor cleaning. DETACHABLE CANISTER MODE Press the handle release button and pull the IMPORTANT: Ensure vacuum is in upright...
Storing Maintenance To reduce the risk of electric shock, unplug the unit before performing any cleaning, maintenance, or troubleshooting checks. Reassemble all parts securely before operating vacuum. DO NOT operate the vacuum without the pre- motor filters and dust cup in place. DO NOT operate the vacuum with WET filters.
COMPONENT MAINTENANCE SCHEDULE Dust Cup Empty each time you vacuum. Pre-Motor Foam Filter Rinse and air dry every 3 months under normal use. Pre-Motor Felt Filter Rinse and air dry every 3 months under normal use. Post-Motor HEPA Filter Clean once every 2 years or as needed. Screen Pre-Motor Filter...
Maintenance - cont’d Fig. 20 Fig. 23 Fig. 21 Fig. 22 Fig. 24 CLEANING THE POST-MOTOR HEPA FILTER CLEANING THE TURBO BRUSH Remove the filter cover from the front of the Slide the locking latch (a) forward and gently tilt vacuum by pulling up on the tab and pulling the brush housing upward to open.
Make sure you are working in a well lit area and use a flashlight to help search for blockages. Rotating Brush Fig. 25 Fig. 26 CHECKING FOR BLOCKAGES CLEANING THE MOTORIZED FLOOR BRUSH Blockages may cause your vacuum to overheat and When your motorized floor brush needs cleaning or shut down.
Ordering Parts Maintenance - cont’d Fig. 27 Fig. 28 • Remove the dust cup and extension wand PART PART NO. and separate the detachable canister from the Pre-Motor Filter Set XFF350 motorized floor brush. Look in all 4 openings for any blockages. (Fig. 27) HEPA Filter XHF350 Motorized Floor Brush...
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum. (See “Maintenance” sections for instructions.) Vacuum is not Dust cup may be full; empty dust cup. picking up dirt.
EURO-PRO FIVE-YEAR (5) LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from material defects and workmanship for a period of five (5) years from the date of purchase when utilized for normal household use, subject to the following conditions, exclusions and exceptions. The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option.