TO REDUCE THE RISK OF FIRE, ELECTRIC ALWAYS BE OBSERVED, INCLUDING THE SHOCK OR INJURY: FOLLOWING: GENERAL ELECTRICAL SAFETY: READ ALL INSTRUCTIONS BEFORE USING 1 Unplug from electrical outlet when not in use and YOUR SHARK NAVIGATOR LIFT-AWAY PRO. ® ™ ®...
Page 3
DUST CUP/FILTERS/ACCESSORIES: HOSE ATTACHMENTS: Before turning on the vacuum: 1 DO NOT use if air flow is restricted; if the air paths, the hose, or the accessories become blocked, turn 1 Make sure that all filters are thoroughly dry after the vacuum cleaner off.
Page 4
This appliance complies with the WEEE-Directive 2012/96/EC on the disposal of electrical and electronic equipment (WEEE). This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material sources.
Contents Thank you for Getting Started purchasing Mode 1: Upright Vac the Shark ® Mode 2: Portable Lift-Away ® Navigator ™ Lift-Away ® Above-Floor Cleaning Lift-Away with Floor Nozzles ® ™ Dust-Away Hard Floor Attachment Use & Care Storage Maintenance...
Getting Started Fig. 2 Fig. 1 Fig. 4 Fig. 3 Fig. 6 Fig. 5 ACCESSORIES: DUST-AWAY HARD FLOOR ATTACHMENT ™ Specialized hard floor attachment vacuums up large particles, then re-usable micro-fibre pad traps extra fine dirt and dust for a superior bare floor clean. (Fig.
Page 7
™ Your new Shark Navigator Lift-Away Pro vacuum cleaner can easily be configured into different ® ® cleaning modes to meet all your cleaning needs: upright vacuum and portable Lift-Away - both with ® constant suction power. Fig. 6 Fig. 7...
Mode 1: Upright Vac To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes. WARNING: The On/Off switch is on the top of the Lift-Away canister. Always ensure the power is OFF ®...
Page 9
Suction Release Collar Release suction for easier push & pull on high pile carpets and area rugs. Fig. 11 Fig. 12 TO USE: Gently press the floor nozzle down with your foot Rotate the cord release to quickly release the power while you grasp the handle and tilt it back towards cord.
Mode 2: Portable Lift-Away ® You can carry your vacuum cleaner in both modes by the carry handle located on top of the dust cup. Fig. 13 Fig. 15 Fig. 14 PORTABLE LIFT-AWAY ® Attach desired accessory onto the end of either the extension wand or the handle.
Above-Floor Cleaning Release suction when dusting delicate objects, furniture or draperies. Fig. 16 Suction Release Collar CLEAN ABOVE THE FLOOR IN UPRIGHT VAC Press the On/Off switch to the “I” position to turn the vacuum on for above-floor cleaning. OR PORTABLE LIFT-AWAY MODE ®...
Lift-Away with Floor Nozzles ® Fig. 17 CLEAN THE FLOOR IN DETACHABLE CANISTER Press the On/Off switch to the “I” position to turn the vacuum on for above-floor cleaning. MODE NOTE: The rotating brush will not rotate in Press the extension wand release button and pull Detachable Canister mode.
Dust-Away Hard Floor Attachment - Use and Care ™ IMPORTANT: Use only in Portable Lift-Away mode. ® Fig. 18 Fig. 19 ATTACH PAD Do not use bleach or fabric softeners as they may damage or leave a coating that will reduce the Slip two of the tabs between the suction nozzle and cleaning performance of the pads.
Storage Quick Cord Release Lower Cord Storage Clip Fig. 20 STORE YOUR VACUUM SAFELY To reduce the risk of electric shock, unplug the unit before performing any cleaning, maintenance, or Convert your vacuum back to upright vac mode. troubleshooting checks. Rotate the upper quick cord release to its upright Reassemble all parts securely before operating position and coil the power cord loosely around the two...
Maintenance COMPONENT MAINTENANCE SCHEDULE Dust Cup Empty each time you vacuum. Pre-Motor Foam Filter Rinse and air dry every 3 months under normal use. Pre-Motor Felt Filter Rinse and air dry every 3 months under normal use. Post-Motor HEPA Filter Clean once every 2 years or as needed.
Maintenance - cont’d Fig. 28 Fig. 25 Fig. 29 CLEANING THE SMALL PET POWER BRUSH Slide the locking latch (a) forward and tilt the bottom cover upward to remove. (Fig. 28) Carefully remove any blockage or debris and cut away any build-up of hair or string wrapped around the rotating bristle brush with scissors.
Rotating Brush Fig. 32 CHECKING FOR BLOCKAGES CLEANING THE MOTORISED FLOOR BRUSH Blockages may cause your vacuum to overheat and shut When your motorised floor brush needs cleaning or locks down. To prevent this from happening, check potential onto an object, it automatically shuts down to prevent blockage areas after heavy use or if you detect a loss of damage to your lifetime belt.
Maintenance - cont’d Ordering Parts Fig. 33 Fig. 34 PART PART NO. Fig. 35 Pre-Motor Filter Set XFF350 HEPA Filter XHF350 Hose and Connections to Vacuum Dusting Brush 172FFJ • D etach the stretch hose from the back of the 14 cm Crevice Tool 1054FT portable Lift-Away canister by squeezing the tabs ®...
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum. (See “Maintenance” sections for instructions.) Vacuum is not Dust cup may be full; empty dust cup. picking up dirt.
(as damage in shipping is not covered by your Limited Warranty). Mark the outside of your package “ATTENTION CUSTOMER SERVICE”. PRODUCT REGISTRATION Please visit www.sharkninjamanuals.com or call 1-800-798-7398 to register your new Shark product within ten ®...
Page 21
(as damage in shipping is not covered by your Limited Warranty). Mark the outside of your package “ATTENTION CUSTOMER SERVICE”. PRODUCT REGISTRATION Please visit www.sharkninjamanuals.com or call 1-800-798-7398 to register your new Shark product within ten ®...