Dust-Away ™ Hard Floor Attachment Use & Care - Shark NV360 Series Owner's Manual

Dust-Away Hard Floor Attachment - Use and Care
™
IMPORTANT: Use only in
Portable Lift-Away mode.
™
ATTACH PAD
Slip two of the tabs between the suction nozzle and
the Dust-Away base and attach them to the front
™
fasteners on the base. Then pull the other two tabs
tightly around to the back fasteners on the base. For
best results, ensure that the pad is flat against the
bottom surface and secured tightly. (Fig. 13)
USING THE DUST-AWAY™ WITH THE EXTENSION
WAND
1 Press the extension wand release button and pull the
extension wand up. (Refer to page 10, Fig. 9-b)
2 Attach Dust-Away™ hard floor attachment onto the
end of the extension wand. (Fig. 14)
3
Press the On/Off switch to the "I" position to
turn the suction motor on and begin cleaning
all hard surfaces.
IMPORTANT: Do not use to clean damp floors or wet/sticky messes.
Fig. 13
a
Fig. 14
Aligning
Rib
USING THE DUST-AWAY™ WITH THE BACKSAVER
WAND
1
Press the release button and pull the handle up.
(Refer to page 10, Fig. 9-a)
2
Align the rib at the top of the Backsaver wand with
the groove inside the vacuum handle and attach it
until it clicks in place. (Fig. 15 a)
3
Attach Dust-Away™ hard floor attachment onto the
end of the Backsaver wand. (Fig. 15)
4
To use the Dust-Away™ hard floor attachment with
the backsaver wand, you should first lock the swivel
mechanism by pressing down on the collar near the
base of the wand. (Fig. 15 b)
5
Press the Button on the Backsaver wand to activate
the Backsaver. (Fig. 15 c)
6 Press the On/Off switch to the "I" position to turn
the suction motor on and begin cleaning all hard
surfaces.
www.sharkninjamanuals.com
The DustAway™
nozzle has a locking
feature which allows
you to lock the nozzle
when you do not want
it to swivel.
c
Unlock
b
Lock
Fig. 15
12