Jump-Start; Mounting The Handle And The Stand; Installing The Wheels - AEG WG 60 User Manual

JUMP-START

▪ Connect the charger clamps to the
poles of the installed vehicle
battery respecting the polarity.
Make sure that they have a good
electrical contact.
▪ Set the voltage selector switch
according to the battery's nominal
voltage.
▪ Connect the device to the wall out-
let and set the mode selector switch
to the „Jump Start" position.
▪ Set the current selector switch to
position 6.
▪ To jump-start the vehicle engine,
press the wired remote control but-
ton and start the engine at the
same time.
▪ Once the vehicle engine has star-
ted, release the remote control
button.
▪ If the engine jump-start fails, the
built-in breaker will release after
approx. 30 seconds.
▪ After cooling down for 3 to 5 minu-
tes, the breaker can be pushed in
again and you can repeat the a-
bove procedure. If necessary,
check the vehicle ignition system
and electrical systems.
▪ Also check the User's Manual for
your vehicle.
▪ We recommend that you first pre-
charge the battery for approx. 5 to
10 minutes.
24
MOUNTING THE HANDLE AND
THE STAND
A handle and two wheels are sup-
plied with the charger. Please make
sure you mount them properly when
assembling these accessories.
1. Pull the handle up to the fixation
hole.
2. Fix the handle on the left and
right sides by using two sheet metal
screws.
3.Install the stand at the bottom of the
device by using 2 sheet metal
screws.

INSTALLING THE WHEELS

1. Insert the bushing from the outside
through the wheel. The bushing
works as a distance piece between
the wheel and the case of the
charger.
2. Fix the wheel with the bolt, nut
and the washer to the case of the
charger.
GB