AEG WG 60 User Manual page 19

▪ Never place the device over or
close to the battery to be charged.
Gases from the battery make the
charger corrode and damage it.
Set up the charger as far away
from the battery as the direct cur-
rent cable allows.
▪ Do not cover the device while
charging.
▪ Never pull the cable or use it to
carry the device. Damaged cables
increase the risk of electric shock.
▪ Only operate the device if all
cables and the casing are intact.
▪ If the supplied cables are damaged
they must be replaced by qualified
specialists to prevent hazards.
▪ Never operate the device if it has
been dropped or damaged in any
other way. For inspection and re-
pair, take it to a qualified electrici-
an.
▪ All maintenance work must be
conducted by qualified electricians.
▪ Never disassemble the device.
Incorrect assembly may cause
electric shock or fire.
▪ Never short circuit the device or
connect the inlets and outlets of
the device using metal objects.
Only use the supplied connecting
cables to connect the device to a
battery.
▪ If an extension cable is used, the
cable diameter must be sufficient
for the power required by the
device.
▪ Check the input voltage (200 - 240
V AC) and ensure that it corres-
ponds to the mains voltage, other-
wise the device may be damaged.
▪ Always make sure that the device
is disconnected from the mains
when you connect it and disconnect
it to a battery.
▪ Always connect the positive clamp
(red) to the positive battery pole
(not connected to the chassis of the
car, marked with P or +).
▪ Then connect the negative clamp
(black) to the negative pole (or
the car chassis), away from the
fuel line. The charger can then be
connected to a suitable power
socket.
▪ After charging, first disconnect the
charger from the power supply.
Then, in this sequence, disconnect
the cable from the negative (-) pole
(or the car chassis), and then the
positive (+) battery connection.
▪ Do not look at the battery when
connecting the charger to the
power supply.
▪ Never try to charge damaged,
non-rechargeable or frozen batte-
ries.
▪ This charger is only suitable for the
listed batteries (maintenance-free,
sealed, lead-acid batteries (SLA))
and may not be used to charge
non-rechargeable, NiCd or other
types of batteries. Do not use it for
any other purposes.
▪ Do not use the charger to charge
dry cell batteries. These may ex-
plode and cause injury to persons
or material damage to property.
GB
19