Overload Protection; Cleaning, Care And Service - AEG WG 60 User Manual

OVERLOAD PROTECTION

If the breaker releases upon over-
load, push the breaker back in until it
clicks into place.
Note: please wait at least 2 minutes
before attempting to reset the breaker
(required cooling time).
The charger features an additional
thermal safety circuit. This thermal sa-
fety circuit protects the charger from
extreme overload and overheating
resulting from improper operation. In
such cases, the charger will power
off automatically and then back on
again after cooling down for approx.
10 to 15 minutes.
If the polarity is reversed, the
fuse will blow and will need to be
replaced. You can find it behind the
black fuse holder cover on the back
panel of the device. Spare fuses are
supplied with the device.
The charger can also power off if the
battery is exceptionally discharged
and demands a very high charging
current. Your device features a
current selector switch, please start
the charging process on level 1 or 2.
After approx. half an hour you can
increase the charging current.

CLEANING, CARE AND SERVICE

Your charger can be kept functional
for years with minimum care.
▪ After the charging process is
completed, clean the clamps. To
prevent corrosion, wipe off any
battery fluid that has come into
contact with the clamps.
▪ Roll up the cables properly when
you store the charger. This helps
to prevent damage to the cables
and the charger.
▪ Occasional cleaning of the charger
casing with a soft cloth keeps the
surface shiny and helps to prevent
corrosion.
▪ Store the charger in a clean and
dry location.
GB
25