Digital Volts-Ammeter; Timer; Finishing The Charging Process - AEG WG 60 User Manual

DIGITAL VOLTS-AMMETER

The built-in voltage/amperage
instrument lets you monitor the current
charging status of the battery at
any time. Toggle between voltage
and amperage to see if the battery
has reached the desired voltage /
charging current. When reaching
a voltage of 7.2 V (6-Volt battery),
14.4 V (12-Volt battery) or 28.8 V
(24-Volt battery) or whenever the
charging current is lower than
< 500 mA, your battery is fully
charged.
The charging current supplied to
the battery and the charging time
depends on the battery status. The
charging current will thus never be
constant during the entire charging
process but will decrease gradually
as the charging level increases.
When connecting the charger to an
empty battery, the charging current
will be high. As the charging level
increases, the charging current will
decrease.

TIMER

The built-in timer allows the charger
to be automatically powered off
after the set time. This means that
the charging process must not be
terminated manually. A battery of a
capacity compatible with the charger
and discharged by 50% can be fully
recharged within 8 to 10 hours. Set
the desired charging time (hours) by
turning the dial knob. After the set
time has elapsed, the charger will
power off.
FINISHING THE CHARGING
PROCESS
1. Power the charger off.
2. Unplug the power cord plug
from the wall outlet.
3. Disconnect the negative clamp
2
(black) from the battery's nega-
tive pole (or from the vehicle chas-
sis).
4. Disconnect the positive (red)
clamp from the battery's positive
pole (labelled P or +).
GB
1
3
23