Hitachi Koki C 10FSH Manual page 16

English
9. Confirmation for use of sub fence (A)...(Optional accessory)
Sub Fence
(A)
6mm Knob
Bolt
Fig. 15
10. Position adjustment of laser line (Only Model C10FSH)
WARNING:
CAUTION:
Fig. 16
Fig. 17
NOTE:
* Perform cutting by overlapping the ink line with the laser line.
* When the ink line and the laser line are overlapped, the strength and weakness of light will
change, resulting in a stable cutting operation because you can easily discern the conformity
of lines. This ensures the minimum cutting errors.
* In outdoor or near-the-window operations, it may become difficult to observe the laser line
due to the sunlight. Under such circumstances, move to a place that is not directly under the
sunlight and engage in the operation.
* Do not tug on the cord behind the motor head or hook your finger, wood and the like around
it; otherwise, the cord may come off and the laser marker may not be lit up.
16
WARNING:
In the case of direct angle cutting and angle cutting, use the sub
fence (A). The sub fence (A) can be installed on the right side of the
guide fence. Insert the rods of the sub fence (A) into the holes in
the guide fence. Tighten the 6mm knob bolt which come with the
sub fence (A) to secure the sub fence (A). Then, you can realize
stable cutting of the material with a wide back face.
* Make sure before plugging the power plug into the receptacle that the main body
and the laser marker are turned off.
* Exercise utmost caution in handling a switch trigger for the position adjustment of
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
* Laser radiation- Do not stare into beam.
* Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
* Do not dismantle it.
* Do not give strong impact to the laser marker (main body of tool); otherwise, the
position of a laser line can go out of order, resulting in the damage of the laser
marker as well as a shortened service life.
* Keep the laser marker lit only during a cutting operation. Prolonged lighting of the
laser marker can result in a shortened service life.
* Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
In the case of right bevel cutting, remove the sub
fence (A). Supposing it is not able to remove it,
It will contact the blade or some part of the tool,
causing in serious injury to operator.