How To Set Up The Incline Trainer - NordicTrack Incline Trainer 9800 User Manual

H S
OW TO ET
Assembly requires two persons. Set the INCLINE TRAINER in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed. Assembly can be completed using the
included allen wrenches.
Note: The underside of the INCLINE TRAINER walking belt is coated with high-performance lubricant. During
shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This
is a normal condition and does not affect INCLINE TRAINER performance. If there is lubricant on top of the walk-
ing belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. Slide the Right and Left Uprights (96, 107) onto the
brackets near the front of the Base Frame (52). Make
sure that the Uprights are on the correct sides; the
indicated holes must be facing the INCLINE
TRAINER.
Raise the Left Upright (107) until the lower hole in the
front of the Left Upright is aligned with the upper hole in
the bracket as shown. Thread an Upright Bolt (106) into
the Left Upright and the bracket. Do not fully tighten
the Upright Bolt yet.
Repeat this step with the Right Upright (96).
2. While a second person holds the Handrail (94) near the
Uprights (96, 107), feed the wires in both sides of the
Handrail down into the Uprights. Pull the ends of the
wires out of the lower ends of the Uprights and remove
the wire ties from the ends of the wires.
Finger tighten four Handrail Bolts (93) into the Handrail
(94) and the Uprights (96, 107) as shown. Be careful to
avoid pinching the wires in the Handrail.
Note: The Accessory Holder (142) and the Cup Holder
(10) are replaceable. If these parts become dislodged
from the Console (89), press them back into place.
3. Connect the Right Upright Wire Harness (105), the TV
Cable (33), and the Left Upright Wire Harness (131) in
the indicated locations. Push all of the excess wire up
into the Uprights (96, 107). Make sure that all wires are
fully connected. Note: Regardless of which console
your INCLINE TRAINER has, connect all wires so that
the console can later be upgraded if desired.
Refer to step 1. While a second person holds the
Uprights (96, 107), remove the Upright Bolts (106). Slide
the Uprights fully onto the Base Frame (52). Be careful
to avoid pinching your hands or the wires.
U I
P THE NCLINE
T
RAINER
1
106
52
2
142
93
94
96
3
105
7
96
107
Holes
106
89
93
Wires
107
96
107
33 131
52
10