Hardware Overview; Ports Panel - Ubiquiti edgepoint r6 Quick Start Manual

EdgePoint EP‑R6 Quick Start Guide

Hardware Overview

Ports Panel

Ground
Bonding Point
Reset
Interface
Ground
Bonding Point
Reset
2
Description
Used to secure a ground wire (not included).
There are two methods to reset the EP‑R6 to
factory defaults:
• Runtime reset (recommended) The
EP‑R6 should be running after bootup is
complete. Press and hold the Reset button
for about 10 seconds until the eth4 LED
starts flashing and then becomes solidly lit.
After a few seconds, the LED will turn off,
and the EP‑R6 will automatically reboot.
• Power-on reset Disconnect power from
the EP‑R6. Press and hold the Reset button
while connecting power to the EP‑R6. Keep
holding the button until the eth4 LED starts
flashing and then stops flashing after a few
seconds.