Centrifugal Juicer - Kenwood multipro FP734 Instructions Manual

centrifugal juicer

Use the centrifugal juice for
making juice from firm fruit and
vegetables.
pusher
lid
strainer
inner bowl
to use the centrifugal
juicer
1 Fit the drive shaft and bowl onto
the power unit.
2 Lock the strainer into the inner
bowl .
3 Fit the inner bowl into the
processor bowl .
4 Place the attachment lid onto
the bowl, turn until it locks and
the feed tube sits over the
handle .
5 Cut the food into small pieces to
fit the feed tube.
6 Switch on and push down
evenly with the pusher - never
put your fingers in the
feed tube. Process fully before adding more.
7 After adding the last piece, let the machine run for a further
20 seconds to extract all the juice from the strainer.
important
If the processor vibrates, switch off and empty the strainer
G
(The processor vibrates if the pulp becomes unevenly
distributed).
Process small amounts at a time (450g maximum) and
G
empty the strainer and inner bowl regularly.
Before processing remove stones and pips (eg pepper,
G
melon, plum) and tough skins (eg melon, pineapple). You
don't need to peel or core apples and pears.
hints
Use firm, fresh fruit and vegetables.
G
Citrus juice will be bitter and frothy because its peel and pith
G
get processed too. Use the citrus juicer instead.
care & cleaning
G
G
G
G
G
m u
lt i
p ro 1 Empty the goblet/jar before unscrewing it from the blade
2 Wash the goblet/jar by hand.
3 Remove and wash the seals.
4 Don't touch the sharp blades – brush them clean using hot
5 Leave to dry upside down.
G
G
G
G
8
Always switch off and unplug before cleaning.
Handle the blades and cutting discs with care - they are
extremely sharp.
Some foods may discolour the plastic. This is perfectly
normal and won't harm the plastic or affect the flavour of
your food. Rub with a cloth dipped in vegetable oil to
remove the discolouration.
power unit
Wipe with a damp cloth, then dry. Ensure that the interlock
area is clear of food debris.
Store excess cord in the
storage area at the back of the
machine .
liquidiser and mini chopper/mill
unit.
soapy water, then rinse thoroughly under the tap. Don't
immerse the blade unit in water.
twin beater geared whisk
Detach the beaters from the drive head by gently pulling
them free. Wash in warm soapy water.
Wipe the drive head with a damp cloth, then dry.
Do not immerse the drive head in water.
all other parts
Wash by hand, then dry.
Alternatively they can be washed on the top rack of your
dishwasher. A short low temperature programme is
recommended.