Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kenwood FP770 series
Summary of Contents for Kenwood FP770 series
- Page 1 FP770 series...
- Page 4 Do not let children use or play with the appliance. plate carrier ● Only use the appliance for its intended domestic use. Kenwood will not accept centrifugal juicer attachment any liability if the appliance is subject to improper use, or failure to comply with spatula these instructions.
- Page 5 to use your liquidiser using the attachments 1 Fit the jug to the power unit. Then fit the drive shaft/bottom blade to the see chart for speed of each attachment. quad knife blade/ dough tool 2 Fit the top blade to the drive shaft, taking care to rotate the top blade clockwise To fit the quad knife blade, first fit the drive shaft onto the metal until it fits fully into place..
-
Page 6: Centrifugal Juicer
● 1 Fit the bowl and drive shaft. If the cord is damaged it must, for safety reasons, be replaced by Kenwood or 2 Select the desired plate and fit into the carrier with the cutting side uppermost. an authorised Kenwood repairer. -
Page 7: White Bread
lasagne white bread 300g (12oz) braising steak, cubed. 500g(1lb 2oz) strong white bread flour 400g can of tomatoes 5mls (1tsp) salt 30mls (2tbsp) tomato puree 15g( ⁄ oz) lard 1 onion 15g ( ⁄ oz) fresh yeast or 10mls(2tsp) dried yeast + 5mls (1tsp) caster sugar. 5mls (1tsp) basil 300mls (11fl oz) warm water, 100mls (3 ⁄... - Page 8 Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK www.kenwoodworld.com 57818/1...
Need help?
Do you have a question about the FP770 series and is the answer not in the manual?
Questions and answers
How do I operate this equipment
1. Preparation
- Read the instructions carefully and retain them for reference.
- Remove all packaging and labels.
- Ensure all parts are clean and properly assembled.
2. Safety Precautions
- Handle blades and plates carefully as they are sharp.
- Always hold the knife blade by the drive shaft, away from the cutting edge.
- Keep hands and utensils out of the processor bowl and liquidiser jug while connected to power.
- Always switch off and unplug before fitting or removing parts.
3. Operating the Food Processor
- Select and fit the desired attachment following the manual instructions.
- Place food into the feed tube and use the pusher to guide it. Never use fingers.
- When using the chipper disc, place ingredients horizontally.
- For slicing or shredding, food placed upright comes out shorter than food placed horizontally.
- Switch on using the on/off speed control or pulse button as needed.
4. Processing Tips
- Use fresh ingredients.
- Do not cut food too small; fill the width of the feed tube to prevent slipping.
- Process small amounts at a time (250g maximum) for best results.
- When using the centrifugal juicer, remove stones, pips, and tough skins before processing.
5. After Use
- Remove the knife blade before pouring contents from the bowl.
- Clean all parts carefully, especially sharp blades.
- Store blades and plates safely in the storage compartment.
This answer is automatically generated