Table of Contents
Advertisement
Available languages
Available languages
SAFETY WARNINGS
•
To prevent short circuits, this product should only be used inside and only in dry spaces.
Do not expose the components to rain or moisture. Do not use the product close to a
bath, swimming pool etc.
•
Do not expose the components of your systems to extremely high temperatures or bright
light sources.
•
In case of improper usage or if you have altered and repaired the product yourself, all guarantees
expire. Marmitek does not accept responsibility in the case of improper usage of the product or
when the product is used for purposes other than specified. Marmitek does not accept
responsibility for additional damage other than covered by the legal product responsibility.
•
Do not open the product: the device may contain live parts. The product should only be
repaired or serviced by a qualified repairman.
•
Only connect the adapter to the mains after checking whether the mains voltage is the
same as the values on the identification tags. Never connect an adapter when it is
damaged. In that case, contact your supplier.
•
This product is not a toy. Keep out of reach of children.
TABLE OF CONTENTS
1.
2.
3.
4.
5.
6.
INTRODUCTION
Congratulated on buying the Marmitek Ir Control Pro 8. With it you can extend the IR (infrared) signals of
remote controls. The IR Control Pro 8 makes it possible to control up to 8 A/V devices while these are in a
closed cupboard or when your A/V equipment is out of sight. The IR Control Pro 8 is a universal IR
extender set and is exchangeable with several other IR products of Marmitek and many other makes.
1. OPERATION
The IR receiver of the IR Control Pro 8 receives the signal of your remote control and converts it into an
electric signal which is relayed to the IR module. Up to 8 IR LEDs can be connected to this module. These
IR LEDs make an IR signal of the electrical signal which is received by the IR sensor of your a/V apparatus.
All signals of your remote control are relayed one to one to all connected IR LEDs. If the IR receiver
receives a signal of your remote control it will light up so that you can check the system if it works
properly.
IR CONTROL PRO 8
TM
3
3
4
4
6
7
8
3
Advertisement
Chapters
Table of Contents
