Makita UH200D Instruction Manual page 14

Installing the hedge shear blades
1
1. Crank
2. Undercover
3. Shear blades
010904
Prepare the crank, the undercover and new shear
blades.
1
1. Basic alignment line on the tool housing
2. Pins
010905
Adjust the three detent pin position so that these three
pins are aligned with the basic alignment line on the tool
housing.
4
1. Crank
2. Apply grease.
3. Pins
4. Recessed part of crank
010906
Fit the crank with its recessed part facing downward
onto the detent pins. At this time, apply a small amount
of grease to the periphery of the crank using grease that
the shear blades as optional accessory are provided
with or that remains inside gear housing.
2
3
2
1
2
3
1. Oval holes that are overlapped
2. Hole in the base plate of shear blades
3. Base plate
010907
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center
of these overlapped oval holes.
Fig.19
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
Fig.20
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
Fig.21
Tighten two screws with a coin or similars firmly.
Fig.22
Place the undercover so that the symbol
undercover is aligned with the symbol
locking lever.
Fig.23
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
Fig.24
At this time, make sure that the locking lever fits in the
groove in the undercover.
CAUTION:
Never use
•
undercover on it.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
14
1
2
the tool without installing
3
on the
on the
on
the