Dell Networking C9010 Installation Manual page 25

Hide thumbs Also See for Networking C9010:

Table of Contents

Lift the chassis and slide it into the rails installed in the rack (Figure 16). Tighten the two thumb

screws and four rack screws (item 5 in Figure 16) on each flange to secure the chassis to the rack.

On a 2-post rack, slide each rail bracket (item 4 in Figure 16) forward to the post. Tighten the two

screws (item 3 in Figure 16) to secure the bracket to each post.

Figure 16. Installing the Chassis with ReadyRails in a Threaded-Hole Rack

Using a Rack Mount Tray (Optional)

You can also use a rack mount tray to install the C9010 switch in a 2- or 4-post rack. Purchase the tray as

a separate item.

NOTE: If the use of a rack bar or Dell ReadyRails does not satisfy your C9010 installation

requirements, Dell Networking recommends using a rack mount tray to support the weight of a

C9010 switch in a 2- or 4-post rack. For information about the chassis weight and other technical

specification, see

Installing the Hardware

Technical

Specifications.

Table of Contents