MrCool DIY Series User Manual page 4

Operation of buttons
7
1 ON/OFF 8
SILENCE
FP
9
TIMER
2
MODE
ON
TEMP
10
3 TIMER
FAN
OFF
11
4
SLEEP
SWING DIRECT
12
TURBO SELF
LED FOLLOW
13
CLEAN ME
5
6
14
For more details visit www.MrCool.com
10
TIMER OFF Button
Press this button to initiate the auto-off time
sequence. Each press will increase the auto
-timed setting in 30 minutes increments.
When the setting time displays 10.0, each
press will increase the auto-timed setting
60 minutes increments. To cancel the auto-
timed program, simply adjust the auto-off
time to 0.0
11 SWING Button
Used to stop or start horizontal louver auto
swing feature.
DIRECT Button
12
Used to change the louver movement and set
the desired up/down air flow direction.
O
The louver changes 6 in angle for each press.
FOLLOW ME Button
13
Push this button to initiate the Follow Me
feature, the remote display is actual
temperature at its location. The remote
control will send this signal to the air
conditioner every 3 minutes interval until
press the Follow Me button again. The air
conditioner will cancel the Follow Me feature
automatically if it does not receive the signal
during any 7 minutes interval.
14
LED Button
Disable/Active indoor screen Display. When
pushing the button, the indoor screen display
is cleared, press it again to light the display.
5 5
Indicators on LCD
Information are displayed when
the remote controller is powered
up.
For more details visit www.MrCool.com
Mode display
AUTO COOL DRY
HEAT FAN
Displayed when data transmitted.
Displayed when remote controller is ON.
Battery display(low battery detection)
Not available for this unit
Displayed when TIMER ON time is set.
Displayed when TIMER OFF time is set.
Show set temperature or room
temperature, or time under TIMER
setting.
Displayed in Sleep Mode operation.
Indicated that the air conditioner is
operating in Follow me mode
Not available for this unit
Not available for this unit
Fan speed indication
Low speed
Medium speed
High speed
Auto fan speed
Note:
All indicators shown in the figure are for the purpose
of clear presentation. But during the actual operation
only the relative functional signs are shown on the
display window.
6 6