Bosch ROTAK 32 Operating Instructions Manual page 13

GB • Printed in England • BA F 016 L69 834 • ROTAK 32/34/34 C • GB • OSW 09/01
F016 L69 834.book Seite 2 Dienstag, 18. September 2001 8:42 08
Product Specification
Cylinder Mower
Part number
Rated power
Blade width
Height of cut
Grassbox capacity
Weight
Protection class
Serial Number
Intended Use
This product is intended for domestic lawn mowing.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately 7.7-12 kg. If necessary, obtain assistance to
remove from packaging.
Take care when carrying the mower to the lawn, as
the blades are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnmower with handle assembly
– 2 Handle bottoms (ROTAK 32)
– 1 Handle bottom (ROTAK 34/34 C)
– 2 Bolts
– 2 Wing nuts
– 2 Screws
– 2 Grassbox halves
– 2 Cable clips
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
13 • F016 L69 834 • TMS • 14.09.01
ROTAK 32
0 600 885 0..
[W] 850
[cm] 32
[mm] 20 – 60
[l] 27
[kg] 7.7
/ II
See rating details on machine
Operating Controls
10 Wheels
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate for a few sec-
onds after the machine is switched off.
Caution - do not touch rotating blades.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz. Only use approved extension ca-
bles. Contact your service agent for details.
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
English - 2
ROTAK 34
0 600 884 0..
1 200
34
20 – 70
40
11.7
/ II
1 Switch lever
2 Safety button
3 Handle top
4 Mains plug**
5 Cable restraint**
6 Grassbox
7 Deflector guard
8 Handle bottom
9 Ventilation slots
For Your Safety
ROTAK 34 C
0 600 884 1..
1 200
34
20 – 70
40
12
/ II