Do you have a question about the Rotak 32 and is the answer not in the manual?
Questions and answers
Bert Emsley
April 4, 2025
Metal strip in handle loose inside so no mower operation
1 comments:
Mr. Anderson
April 4, 2025
To fix a loose metal strip in the handle of a Bosch Rotak 32 mower that prevents operation:
1. Disconnect the mower from the mains. 2. Inspect the handle area where the metal strip is located. 3. Ensure the strip is properly seated and making contact when the handle is pressed. 4. If it is bent or out of place, carefully reposition it so it aligns correctly with the switch mechanism. 5. If damaged, the metal strip may need to be replaced.
Page 1
OBJ_DOKU-24112-004.fm Page 1 Tuesday, February 4, 2014 7:52 AM Robert Bosch GmbH Power Tools Division 70745 Leinfelden-Echterdingen Rotak Germany www.bosch-garden.com F 016 L70 768 (2014.02) O / 10 XXX en Original instructions...
Always stand clear of the discharge zone when operating machine out of reach of children. the machine. Never pick up or carry the machine while the motor is run- ning. F 016 L70 768 | (4.2.14) Bosch Power Tools...
See the operating instructions for the order no. and types. If the supply cord is damaged, it must be replaced by a Bosch Service Centre. Never touch the mains plug with wet hands.
Customer Contact Center Uxbridge Inside Australia: UB 9 5HJ Phone: (01300) 307044 At www.bosch-pt.co.uk you can order spare parts or arrange Fax: (01300) 307045 the collection of a product in need of servicing or repair. Inside New Zealand: Tel. Service: (0844) 7360109 Phone: (0800) 543353 E-Mail: boschservicecentre@bosch.com...
Page 6
Equipment and its implementation into national law, electrical and electronic equipment that are no longer usable must be collected separately and disposed of in an environmentally correct manner. Subject to change without notice. F 016 L70 768 | (4.2.14) Bosch Power Tools...
Page 7
OBJ_BUCH-1349-004.book Page 7 Tuesday, February 4, 2014 7:53 AM 6,6 kg STOP Bosch Power Tools F 016 L70 768 | (4.2.14)
Page 8
OBJ_BUCH-1349-004.book Page 8 Tuesday, February 4, 2014 7:53 AM 60 mm 40 mm 20 mm STOP F 016 L70 768 | (4.2.14) Bosch Power Tools...
Page 9
OBJ_BUCH-1349-004.book Page 9 Tuesday, February 4, 2014 7:53 AM S TOP Auto-Stop 60 sec Start S TOP F 016 800 383 Bosch Power Tools F 016 L70 768 | (4.2.14)
Need help?
Do you have a question about the Rotak 32 and is the answer not in the manual?
Questions and answers
Metal strip in handle loose inside so no mower operation
To fix a loose metal strip in the handle of a Bosch Rotak 32 mower that prevents operation:
1. Disconnect the mower from the mains.
2. Inspect the handle area where the metal strip is located.
3. Ensure the strip is properly seated and making contact when the handle is pressed.
4. If it is bent or out of place, carefully reposition it so it aligns correctly with the switch mechanism.
5. If damaged, the metal strip may need to be replaced.
If the problem persists, contact a service agent.
This answer is automatically generated