REASSEMBLY PROCEDURES
23. Install a new poppet seat into the poppet.
24. Install the adjustment screw into the valve body with an initial insertion of only one or two threads showing.
25. Place spring (7) inside valve body (1).
26. Install Thrust Washer onto the Poppet and then use Poppet Installation Tool to guide Poppet and Thrust Washer
into the Valve Body. Note that notch in the poppet must align with the cross hole in the valve body. After the
poppet is aligned, insert the cam with the flat side facing toward the spring to capture the poppet.
27. Reinstall lever onto the cam – orient the lever properly as shown.
WARNING – Failure to install the lever with the proper orientation as shown will cause extremely
poor performance and the cam to eventually dislodge from its position once the valve body is
mounted into the housing. If the regulator is used with the wrong lever orientation it will lead to a
dangerous catastrophic failure underwater.
www.sherwoodscuba.com
15