Table of Contents
Advertisement
7.
Remove the O-ring (11) from the access plug and set aside for cleaning (it will be reused).
8.
Use a 3/4" (19mm) wrench to remove the inlet connector from the housing. Remove O-ring and set aside
for cleaning.
9.
Slide valve body (1) back and lift upward to remove it from the housing.
10. Use Orifice Installation Tool (20-900-100) to remove the adjustable orifice from the inlet connector. The
adjustable orifice is threaded and must be rotated counterclockwise and then pushed with a blunt probe for
removal.
www.sherwoodscuba.com
10
Hide quick links:
Advertisement
Table of Contents
