Battery Replacement Procedures - Sherwood Scuba Profile Manual

N
NOTE: Sherwood Scuba strongly advises that you replace the Battery and
DO NOT attempt to dive when the Battery icon remains on the display, and
that you replace the Battery with a new one prior to any multi day dive trip.

BATTERY REPLACEMENT PROCEDURES

Module Removal from Boot
If the Profile is in a Wrist Boot, it will be necessary to peel the lips of the Boot downward off the
Module while applying pressure from underneath, working it out slowly.
If it is in a Console, bend the rubber Console Boot back to expose the edge of the Module. If the
Boot is flexible enough to permit, you may bend it back far enough to scoop the Module out with
your finger. Otherwise, it may be necessary to insert a blunt screwdriver until the tip rests just un-
derneath the Module. DO NOT pry the Module from the Console! Slowly increase the pressure
under the Module by releasing the tension on the rubber Boot. The Module will slide up the
screwdriver and exit the Console.
CAUTION: The procedure that follows must be closely adhered to. Damage
due to improper battery replacement is not covered by the Profile's limited
2 year warranty.
Profile
Responsible
57