Adjustments - Exmark LAZER Z ADVANTAGE SERIES Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.28
4.1.29

4.2 ADJUSTMENTS

IMPORTANT: Disengage PTO, shut off engine, wait for all moving parts to stop,
and remove key before servicing, cleaning, or making any adjustments to the unit.
4.2.1
d) Caster wheel spacer nuts
e) Fuel tank bulkhead fitting nuts.
f) Cutter housing spindle nut.
Adhesives such as "Loctite RC/609 or RC/680" or "Fel-Pro Pro-Lock Retaining I
or Retaining II" are used on the following:
a) Fuel tank studs, where studs are inserted into tank.
Mobil HTS grease (or food-grade antiseize) is used in the following locations:
a) Between the cutter housing spindle and bearings.
b) Between the cutter housing spindle and sheave.
c) Under top cutter housing bearing guard.
d) Between jackshaft and bearings and jackshaft and sheaves.
Dielectric grease is used on all blade type electrical connections to prevent
corrosion and loss of contact.
Cutting Height Adjustment.
a) Stop machine and move drive levers out to neutral lock position.
b) Disengage PTO.
c) Raise the deck lever to the transport position (also the 4.5" (11.4 cm)
cutting height position). See Figure 5.
The deck can be raised by pulling the deck lever up.
NOTE: When changing cutting height positions, always come to a
complete stop and disengage the PTO.
CUTTING HEIGHT POSITION
d) Insert height adjustment pin into hole corresponding to desired cutting
height and install hairpin cotter. See decal on the side of deck lift plate.
e) Move lever out of transport (or 4.5" (11.4 cm) cutting height) position and
down onto height adjustment pin to mow at selected height.
f) To transport, move lever back up to transport (or 4.5" (11.4 cm) cutting
height) position.
g) Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in one
of the positions shown in Figure 10. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
For Maximum Deck Flotation, place rollers one hole position lower.
Rollers should maintain 1/4 in. (6.4 mm) minimum clearance to ground. Do
Not adjust rollers to support the deck.
www.mymowerparts.com
FIGURE 5
- 28 -