Exmark LAZER Z ADVANTAGE SERIES Operator's Manual page 29

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.13
4.1.14
4.1.15
∗ See Section 4.1.15 c) for special lubrication instructions on the front caster pivots and
Section 4.1.16 for special lubrication instructions on the front casters wheel hubs.
NOTE: The baffle is labeled "HOT" and "COLD". The oil level varies with
the temperature of the oil. The "HOT" level shows the level of oil when it is
at 225°F (107°C). The "COLD" level shows the level of the oil when it is at
75°F (24°C). Fill to the appropriate level depending upon the temperature
of the oil. For example: If the oil is about 150° F (65°C), fill to halfway
between the "HOT" and "COLD" levels. If the oil is at room temperature
(about 75° F (24°C)), fill only to the "COLD" level.
Check tire pressures:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Check tire pressure in drive tires.
c) Inflate drive tires to 13 psi (90 kPa).
d) Check tire pressure in Caster tires.
e) Inflate caster tires to 13 psi (90 kPa).
NOTE: Do not add any type of tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling tires will void the warranty.
Check condition of belts:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up. Lift the rubber flap on front side of the
engine to check pump drive belt.
c) Remove left and right belt shields on deck and lift up floor pan to inspect
deck drive belt.
d) Check under machine to inspect the mule drive belt.
e) See Sections 4.2.3, through 4.2.5 for belt adjustment.
Lubricate grease fittings:
Service Interval: Refer to chart.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose
gun grease.
Refer to the following chart for fitting locations and lubrication schedule.
LUBRICATION CHART
FITTING
LOCATIONS
1. Front Caster wheel hubs
2. Front Caster Pivots
3. Height Adj. Shaft Bearings
4. Deck Drive Belt Idler Arm
5. Brake Brackets
6. Mule Drive Belt Idler Arm
7. Pump Drive Belt Idler Arm
8. Deck Rear Struts
www.mymowerparts.com
INITIAL NO. of
PUMPS PLACES
∗0
2
∗0
2
1 5
1 1
1 2
1 1
1 1
1 2
- 24 -
SERVICE
INTERVAL
∗yearly
∗yearly
40 hours
Yearly
200 hours
Yearly
Yearly
40 hours