Door Lock Assembly; Bellows - Electrolux EWFLW65H Technical & Service Manual

Door Lock Assembly Removal
The door lock assembly is secured with two screws to
the front of the unit frame. The wire harness is attached
to backside of the door lock assembly.
To remove the door lock assembly:
1. Using a #2 square bit screwdriver, remove 2 short
course-thread, panhead screws from the door lock.
(See Figure 4-13)
2. Slide the lock toward the outer edge of the front
panel. Pivot the lock slightly outward while slowly
pulling it through opening to expose the attached
harness. (See Figure 4-14)
3. Release the harness from the terminal with the small
lever on back of the lock. Separate the harness
from the lock, allowing the harness to lay outside the
front panel. (See Figure 4-15)
Bellows Removal
The bellows or boot gasket provides a seal for the
washing compartment and a mounting cavity for the
interior light and the Advanced Rinse Technology (ART)
hose. A spring loop retains the bellows to the front panel
of the washer and to the inner wash tub. The bellows
must be released from the front panel before removing
the front panel to access the spring loop on the wash
tub.
To remove the bellows:
1. Remove the door.
2. Pull back the top section of the bellows at the top of
the wash compartment opening.
3. Extract the LED light assembly from the bellows.
4. Using a pliers, remove the ART hose from the left
underside of the detergent dispenser.
5. Using a needlenose pliers, pull the spring loop out
from the retaining lip of the bellows.
(See Figure 4-16)
6. Pull the front of the bellows off the lip of the front
panel to release it.
7. Remove the bellows by placing your hand under
the bellows at the top of the opening and lift up
while pulling out. A second spring loop secures the
bellows to the wash tub.
Component Teardown
Spring
Loop
4-5
Figure 4-13.
Figure 4-14.
Figure 4-15.

Bellows

Figure 4-16.