Tub Assembly - Electrolux EWFLW65H Technical & Service Manual

Component Teardown
Tub Assembly Removal
When removing the tub assembly, be sure to have a
protective material on hand to protect the flooring of
the home, such as Masonite, plywood, 1/8" pressed
fiberboard or cardboard or some other suitable material.
To remove the tub assembly:
1. Disconnect the washer from the electrical supply and
the hot and cold water hoses.
2. Remove the top panel, console, rear access panel
and the front panel.
3. Disconnect and remove the advance rinsing
technology hose and light from the bellows, and the
detergent outlet and siphon break hoses from the
outer tub.
4. Remove the drain pump and disconnect the drain
sump from the tub.
5. If replacing the front half of the outer tub remove the
bellows and the weight ring.
6. Remove the small hose from the air bell.
7. Remove the large pulley, drive motor and speed
control board assembly.
8. Remove the top pins from shock absorbers and push
the shock absorbers against the cabinet.
9. Place protective material on floor, then carefully turn
the washer on its face and release the suspension
springs.
10. Lift the cabinet off the tub. The rear of the wash tub
will face upwards. (See Figure 4-57)
11. Turn the tub over and remove the (23) bolts securing
the two halves of the tub together. (See Figure 4-58)
12. Lift off the front half of the tub.
13. Reverse procedure to reassemble using illustration
below to show outer tub screw tightening sequence.
(See Figure 4-59)
Rear of Wash Tub
7 of 23 shown
4-20
Figure 4-57.
Bolts
Figure 4-58.
Figure 4-59.