How To Run A Wash Cycle - Electrolux EWT 11730 W User Manual

How to run a wash cycle?

Using for the first time
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
Daily use
Loading washing
• Open the lid of the appliance.
• Open the drum by depressing the loc-
king button A : The two shutters
unlock automatically.
• Load the washing, close the drum
and the lid of your washing machine.
A
Before closing the lid of your appliance,
ensure that the drum is properly closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Your washing machine has been desi-
gned to reduce your water and deter-
gent consumption. You can therefore
how to run a wash cycle 9
reduce the amounts recommended by
detergent manufacturers.
Pour the amount of washing powder into
the washing and prewash
partments if you have selected the
"prewash" option. Pour fabric softener
into the compartment if necessary
If you use another detergent type, refer
to the section "detergents
additives" in the washing guide.
Selection of desired programme
You can find the right programme for
different types of washing in the pro-
gramme table (see "Programme ta-
ble").
Turn the programme selector to the
required programme. The "Start/Pause"
pushbutton flashes green.
The symbols which correspond to the
different stages of the cycle are
displayed ( Prewash,
Rinse, Drain, Spin).
If you turn the programme selector to
another programme while a cycle is in
progress, the appliance will ignore the
new selected programme. "Err" flashes
and the "Start/Pause"
flashes red for a few seconds then the
current cycle display reappears.
com-
.
and
Wash,
pushbutton