Detergent Drawer Removal And Breakdown; Console Panel - Electrolux EWFLW65H Technical & Service Manual

Component Teardown

Detergent Drawer Removal and Breakdown

To open, press the button on the front of the detergent
drawer. Pull drawer open, then push down on the
release tab and pull the drawer out of the unit.
(See Figure 4-23)
To breakdown the dispenser drawer:
1. Remove the drawer from the washer.
2. The detergent, liquid bleach and fabric softener
insert lifts off the drawer assembly. When installing,
be sure to seat it properly.
3. To separate the drawer front, release the three tabs
and pull the drawer front away from the body.
4. To remove the conveyer, release the conveyer
from the tabs and lift it off.
Console Panel Removal
The console panel provides a cover for the detergent
dispenser drawer and a mounting surface for the user
interface and LCD screen. Screws secure the console
panel to the unit frame. The wire harness connects to
the control assembly at the far right hand side behind the

console panel.

To remove the console panel:
1. Remove the detergent drawer and top panel.
2. Using a #2 square bit screwdriver, extract the three
screws from the detergent drawer area.
(See Figure 4-24)
3. From the top front of the washer, extract the two
screws, one on each end, securing the console to
the top of the side panels. (See Figure 4-25)
4. Pull the bottom of the console forward, while lifting
up to release the bottom tabs from the front panel.
Use care not to strain the wire harness connections
to the control assembly.
5. Rotate the console until the electrical connection is
visible. Disconnect the electrical connection from the
control assembly.
4-8
Release Tab
Figure 4-23.
Screws
Figure 4-24.
Screws
Figure 4-25.