Interior Light; Top Panel; Vibration Dampener - Electrolux EWFLW65H Technical & Service Manual

Interior Light Removal
The interior light is an LED assembly that presses into a
hole in the top of the bellows. The wire
harness connection is located near the controller
assembly.
To remove the LED assembly:
1. Remove the door trim ring, the door and release the
bellows from the front panel.
2. Remove the console and front panel.
3. Pull the bellows down to access the LED assembly
and extract from the bellows. (See Figure 4-20)
4. Disconnect the wire harness from the LED
assembly wire leads.
Top Panel Removal
The top panel is secured with a metal tab at each front
corner and two screws at the rear of the unit.
To remove the top panel:
1. Pull unit from its installation position to access the
rear of the unit.
2. Using a #2 square bit screwdriver, extract the two
screws securing the top panel to the unit frame.
(See Figure 4-21)
3. From the front of the unit, push the top panel
towards the rear until free of the metal tabs, then lift
top panel off of unit.
Vibration Dampener Removal
The vibration dampener is located directly behind the top
brace and is secured with screws to the unit frame.
To remove the vibration dampener:
1. Using a #2 square bit screwdriver, extract the four
screws securing the vibration dampener to the unit
frame. (See Figure 4-22)
2. Lift the vibration dampener from the unit.
Component Teardown
ART Hose
4-7
LED
Bellows
Figure 4-20.
Screws
Figure 4-21.
Screws
Figure 4-22.