Getting Started; Assembling Your Steam Mop - Shark S2901UKE Owner's Manual

Getting Started

When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our
steam mops 100% before you buy them, so you get a quality Shark
a
b
c
d
e
f
g
h
i
a
Mop Handle
b Cord Clip
c
Water Tank Cap
d
Handheld Steamer
e Power Button
f
Release Button
g
Rectangle Mop Head
h Cleaning Pocket for Rectangle Head (x2)
i
Carpet Glider
5 FREEPHONE 0800 862 0453
Multi-Function Steam Pocket Mop Lite S2901.
® ®
j
k
l m
n
o
p
j
Accessory Hose
k Window Squeegee
l
Flat Scrubber Tool
m
Flat Scrubber All-Purpose Bonnet
n Concentrator Nozzle
o
Grout Scrubber Brush
p
Filling Flask

Assembling Your Steam Mop

fig. 1
IMPORTANT: Always make sure the mop is
UNPLUGGED from the wall when not in use.
Never fill the mop, attach the mop head,
change or remove the cleaning pocket when
the mop is plugged into the wall. To prolong
the life of your Shark Multi-Function Steam
®
Pocket Mop Lite S2901 we recommend using
®
distilled water. Make sure you only add water
to the tank. Chemicals or cleaning solution
may damage the appliance and could be
unsafe for you and your family.
fig. 2
STEAM MOP ASSEMBLY
1
Insert the Mop Handle end with the " " facing the
front of the unit into the handheld steamer. Push the
mop handle in until you hear it click into place. (fig. 1)
2 Fit one side of the pocket onto the head first, then
using the loop, pull the pocket over the head. Attach
the quick fasteners on the top of the pocket to
secure in place.
3
Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place. Press the release button to
remove or change the mop head. (fig. 2)
www.sharkclean.eu 6