Using Your Steam Mop; Using Your Carpet Glider - Shark S2901UKE Owner's Manual

Using Your Steam Mop

IMPORTANT: Make sure you do not use the mop
without attaching a cleaning pocket and adding
water to the tank first. When you are using the
mop for the first time, it might take longer than
the normal 30 seconds to start steaming.
fig. 3
fig. 4
1
Turn the water tank cap anticlockwise and remove
from the tank. (fig. 3)
2
Use the filling flask and pour water into the tank. Do
not overfill. Replace the cap on the water tank. (fig. 4)
IMPORTANT: Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have
been treated with wax or some no wax floors,
the sheen may be removed by the heat and
steam action. It is always recommended to test
an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the
floor manufacturer.
7 FREEPHONE 0800 862 0453
fig. 5
fig. 6
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to cleaning
with your Steam Mop.
3
Pull and twist the quick release cord holder to
unwrap the power cord completely. Plug into an
electrical outlet. (fig. 5)
4
Press the power button to turn the unit on. (fig. 6)
5
Clean your floors with a forward and backward motion.
fig. 7

Using Your Carpet Glider

fig. 8
THE CARPET GLIDER
1
The Carpet Glider can be used with the Rectangular
Head to lightly steam your carpet and area rugs.
Just place the mop head with cleaning pocket
attached into the glider. (fig. 8)
6
Use the shaggy side of the cleaning pockets to lift
up and lock away all the dirt and debris and the
scrubbing side to break up the tough stains. (fig. 7)
7 When the water tank is empty, the Steam Mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the outlet. Follow the instructions from page 7. This
applies to switching the mop head or cleaning pocket
as well.
NOTE: Please wait 2-3 minutes for the Steam Mop
to cool off before switching the mop head or the
cleaning pocket. Never leave the Steam Mop with a
damp/wet cleaning pocket on any floor.
8
When you are done, press the power button to turn
the steam mop off.
The Steam Mop will not clean your
carpeting or area rugs. However, it is
great for grooming and freshening.
fig. 9
2
Move the Steam Mop back and forth across a
section of the carpet. (fig. 9)
www.sharkclean.eu 8