Getting Started; Assembling Your Steam And Scrub Mop - Shark S7201 Series Instructions Manual

Steam and scrub mop

Hide thumbs Also See for S7201 Series:

GETTING STARTED

When assembling your steam mop there may be a little water in or around the water tank.

This is because we test all our steam mops before you buy them, so you get a quality Shark®

Steam and Scrub Mop.

A Steam Mop Handle

B Quick-Release Cord Holder

C Steam Mop Body

D Floorhead

s h a r kc l e a n . c o . u k

E Water Tank Lid

F Mode Button

G Steam Blaster

H Steam Blaster Button

Dirt Grip Pads

J Filling Flask

Insert the mop handle into the steam

mop body until it clicks into place.

NOTE: Once the handle has been inserted,

it is locked and cannot be removed.

3 To open the water tank, pull the lid down.

Unplug the steam mop before refilling the

water tank.

2 To attach the Dirt Grip pads, place

BOTH the pads flat on the floor with

the plastic rings facing up. Align the

indentation on the rotating discs on the

bottom of the nozzle with the plastic

rings on the pads, then gently lower the

nozzle onto the pads, pressing until the

pads are secured.

4 Use the filling flask to pour distilled water

into the tank. Make sure to not exceed the

Max Fill line on the flask. When finished,

close the tank lid firmly.

NOTE: Max capacity of the water tank is 320ml

s h a r kc l e a n . c o . u k

Table of Contents