Table of Contents
Advertisement
6
PAN/TILT ZOOM
The monitor is equipped with a built-in Pan/Tilt Zoom feature, which is only available when used
in conjunction with a compatible Sylvania Pan/Tilt Zoom (Zoom optional) Dome camera.
(model SG7380)
Please refer to www.sylvaniasecurity.com for more information on the available accessories (sold
separately).
The Pan/Tilt Zoom feature supports "Pelco D" protocol, and operates via the 6 Pin DIN
connection on Channel 1. To access and operate the PTZ feature, follow these instructions:
1
Connect a compatible Sylvania Pan/Tilt Zoom Dome camera to Channel 1;
2
Go to the SYSTEM submenu and set the PAN/TILT(CH1) option to "Y";
3
EXIT the menu.
4
Enter Pan/Tilt Zoom mode by holding the PAN/TILT key on the monitor for 3 seconds, or
press the Pan/Tilt button on the remote control;
5
You will see a contracted screen with a blue border. Use the Arrow keys to sideways, and
ENTER to select whether to MOVE, ZOOM, or FOCUS the camera. (note: Focusing is
currently not available on the SG7380 Dome camera).
6
If you have selected MOVE, you can use all four arrow keys to Pan and Tilt in all
directions. If you selected ZOOM, use the ▲▼arrow keys to Zoom / Focus IN / OUT.
7
Select and press ENTER on the EXIT option to escape Pan/Tilt mode.
The system automatically exits Pan/Tilt mode after 20 seconds of inactivity. When the
NOTE
PTZ camera is active the external alarm function on channel 1 will be disabled, but the
internal pixel motion alarm will function
Refer to the diagram below for an illustration of Pan/Tilt Zoom mode.
MOVE
[CH1 PAN/TILT MODE]
ZOOM
FOCUS
- 9 -
EXIT
Advertisement
Table of Contents
