Table of Contents
Advertisement
c)
4
Title Set – This submenu allows you to change the title of each camera location (up to 8
characters), or remove the titles from the on-screen display.
a)
b)
5
System Set - This sub-menu allows you to configure various preferences on the system.
a)
b)
c)
d)
e)
You may see a white screen in VCR mode if VCR OUT is set to ACTUAL due to a loss
NOTE
in the video loop back. This is not a problem, as recording is still functioning properly.
f)
g)
h)
i)
6
Monitor Set – Adjust the monitor's Contrast and Brightness. You will see this menu on
your camera setting rather than on a blue background, enabling you to see the changes
being made to the picture.
you can switch between Quad and Full Screen views while adjusting the monitor
NOTE
settings by pressing the
7
Exit – Select exit to return to the previous viewing mode.
NOTE
20 seconds of inactivity in Menu mode will also exit the Menu.
POP POSITION: There are two different viewing options for POP
display.
DISPLAY: Selecting [Y] will enable the camera titles to appear in the on-
screen display.
Selecting [N] will remove all titles from appearing in the on-screen
display.
CH 1 - 8: Change the titles of each individual camera.
KEY BUZZER: When set to [Y], the system will make a sound when a
key is pressed on the remote control or on the main panel of the
monitor.
LOSS BUZZER: When set to [Y], the system will make a sound when a
camera becomes disconnected.
QUAD LINE: Activates and deactivates the border line in Quad mode.
BLANK COLOR: Choose between blue, gray or black as the
background screen color in Menu Mode.
VCR OUT: When set to [ACTUAL], the system will output what is
shown on the monitor to a VCR. When set to [QUAD], the VCR will
record Quad mode, regardless of what's appearing on the screen.
TITLE/TIME: Change the location of on-screen display for Time/Date
and camera Titles. T/R/B/L represent Top / Right / Bottom / Left
respectively. Therefore, for example, the setting "TR/BL" would display
the Title in the Top-Right corner of the screen, and the Time in the
Bottom Left corner.
PAN/TILT(CH1): Activates Pan/Tilt mode to become accessible.
ALARM OUT:
Select the Alarm Out setting, which is defaulted to NO
(Normally Open).
DEFAULT SET: Selecting [Y] resets all programmed settings, except
for the date & time settings, back to the default factory settings.
,
buttons.
- 8 -
Advertisement
Table of Contents
