End Of The Programme; After Washing/Drying - Bosch WVH28422GB Instruction Manual And Installation Instructions

End of the programme

– 0 – or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal~ Page 27
If $ (Rinse stop = without final drain/
spin cycle) was selected, press
A Start/Reload button to start the final
drain/spin cycle.
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the
A Start/Reload button before the
spin cycle starts, then turn the
programme selector to Ú Off. The
programme is interrupted and the
door lock is released. The laundry
can be removed.
If hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Operating the appliance

After washing/drying

Open the door and remove the
1.
laundry.
Turn the programme selector to
2.
Ú Off. The appliance is switched off.
Turn off the tap.
3.
Not required for Aqua-Stop models.
~ Page 37
Notes
Do not leave any items of laundry in
■
the drum. In the next wash they may
shrink or discolour another item.
Remove any foreign objects from
■
the drum and the rubber seal – risk
of rust.
Leave the detergent drawer and
■
door open so that residual water can
evaporate.
Always remove the laundry.
■
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
When the display panel has gone
■
out at the end of the programme,
energy-saving mode is active. To
activate, select any button.
en
19