Connecting The Water; Water Supply - Bosch WVH28422GB Instruction Manual And Installation Instructions

Installation and connection
en
If the hose holders are used, the
Note:
possible hose lengths are reduced!
Available from dealer/customer
service:
Extension for Aqua-Stop or cold
■
water inlet hose (approx. 2.50 m).
Order no. WMZ 2380, WZ 10130,
CZ 11350, Z 7070X0.
Longer supply hose (approx.
■
2.20 m), for standard model.

Connecting the water

:
Warning
Risk of electric shock!
Danger of death if live parts come into
contact with water.
Do not immerse the Aqua-Stop safety
device in water (it contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply and water drainage hoses are
under high pressure. To prevent
leakage or water damage, always follow
the instructions in this chapter!
Notes
In addition to the safety information
■
listed here, the local water and
electricity supplier may have special
requirements.
Operate the washer dryer with cold
■
drinking water only.
Do not connect the washer dryer to
■
the mixer tap of an unpressurised
hot water boiler.
Use only the inlet hose supplied or
■
one purchased from an authorised
specialist outlet. Never use an used
one!
If in doubt, have the appliance
■
connected by a technician.
40

Water supply

Notes
Do not kink, crush, alter or cut
■
through the water supply hose
(otherwise, its strength can no longer
be guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too tightly using a tool
(pliers), the threads may be
damaged.
Optimum water pressure in the mains:
100–1000 kPa (1–10 bar)
When the tap is turned on, the water
■
flow is at least 8 l/min.
If the water pressure is higher, install
■
a pressure reducing valve.
Connect the water supply hose to
1.
the tap (¾" = 26.4 mm) and to the
appliance (except models with
Aquastop):
– Standard
– Aqua-Secure
– Aqua-Stop