Operating the appliance
en
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the A Start/Reload button. The
washer dryer checks whether reloading
is possible.
Notes
If there is a high water level, high
■
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not possible.
To continue the programme, select
the A Start/Reload button.
Do not open the door until the door
■
lock symbolÕ goes out.
Do not leave door open for
■
a prolonged period – water could
run out of the laundry.
The reloading function cannot be
■
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select A Start/Reload.
1.
Select another programme. If
2.
required, adjust the default settings
and/or select additional functions.
Select A Start/Reload. The new
3.
programme starts from
the beginning.
30
Interrupting or ending the
programme
For washing programmes at high
temperature:
Touch A Start/Reload button.
1.
To cool down laundry: select
2.
O Rinse.
Touch A Start/Reload button.
3.
For washing programmes at low
temperature:
Touch A Start/Reload button.
1.
Select Spin/Drain 0/[.
2.
Touch A Start/Reload button.
3.
For drying programmes:
Select Intensive Dry 5 or Gentle
1.
Dry ‰.
Touch Š Dry button, and set drying
2.
time to 20 minutes.
Touch A Start/Reload button.
3.
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
A Start/Reload button to start the final
drain/spin cycle.