How To Operate - Sharp DW-E16FA Operation Manual

HOW TO OPERATE

LAUNDRY DRYING
When drying laundry
Select
LAUNDRY.
1
Beep
Beep
Select your desired fan speed.
Beep
HIGH
Dry laundry with continuous operation of "HIGH" fan speed
HIGH
MED
Dry laundry with continuous operation of "MED" fan speed
Beep
2
MED
LOW
Dry laundry with continuous operation of "LOW" fan speed
Beep
AUTO (Auto stop)
LOW
When you want to dry your laundry but with less power consumption
Dehumidifying operation (compressor operation) and Air Flow operation (compressor
Beep Beep
stopped) will alternately repeat with "HIGH" fan speed and dry the laundry.
AUTO
● The operation will automatically stop when the humidity level falls below 60% after
about 30 minutes of operation or when the unit has operated for about 3 hours.
(A long beep will sound when the operation stops and the Laundry indicator light will blink.
To operate again, press the OFF button)
※1 If the Auto Off function is not disabled, the operation will stop after 12 hours.
※2 The fan speed may increase with the room temperature.
Beep
Select your
3
desired louver
angle.
● Stretch the wrinkles of wet laundry and dry in an airy place.
● Dry thick laundry in a well ventilated place.
NOTE
● The drying time will be longer for a low temperature room, large room, and when the quantity of laundry is large.
Laundry drying operation may stop even the laundry has not been dried when the fan speed is set to "AUTO".
This is not a malfunction.
Conduct Auto operation again for more drying time.
E - 14
NOTE
Do not block the air
outlet with clothes, etc.
[Otherwise, over-heating, fire or malfunction may be caused]
● "LAUNDRY" will operate immediately after the
power plug is plugged in.
● Unless the power plug is unplugged, the unit
will operate in the last mode that was selected.
● The AIR PURIFYING indicator light remains on.
.
※1
.
※1 ※2
.
※1 ※2
E - 11
E - 3
● Make sure the air
blowing out from air
outlet is directly pointing
to your laundry.
E - 18
The distance between air
outlet and laundry should
be 10cm or more.
DEHUMIDIFYING
When you want to dehumidify, prevent dew formation on the ceiling,
wall or window glass, or dry your tatami or closet.
Select
DEHUMIDIFY.
1
Beep
Beep
Select your desired fan speed.
Beep
HIGH
Dehumidify with continuous operation of "HIGH" fan speed
HIGH
MED
Dehumidify with continuous operation of "MED" fan speed
Beep
MED
2
LOW
Dehumidify quietly with continuous operation of "LOW" fan speed
Beep
LOW
AUTO
When you want to automatically dehumidify
Beep Beep
With the "odor, temperature and humidity sensor", the unit will monitor the room
AUTO
condition and automatically switch the fan speed
for continuous operation .
※1
Adjust the dehumidification amount for proper
humidity level according to the room temperature.
When the room temperature is too low or too high,
it might not reach the appropriate humidity level.
※1 If the Auto Off function is not disabled, the operation will stop after 12 hours.
※2 The fan speed may increase with the room temperature.
Beep
Select your desired
3
louver angle.
● "LAUNDRY" will operate immediately after the
power plug is plugged in.
● Unless the power plug is unplugged, the unit
will operate in the last mode that was selected.
● The AIR PURIFYING indicator light remains on.
.
※1
.
※1 ※2
.
※1 ※2
Room Appropriate
temperature humidity
3°C-26°C 60%
26°C-38°C 55%
E - 28
E - 11
E - 3
E - 18
E - 15