For Heavy Dust / E - Sharp DW-E16FA Operation Manual

CARE AND
MAINTENANCE
REAR PANEL
1
WATER TANK
Tank lid
1
2
3
Check float
Tank lid
4
E - 24
WARNING
Always turn the operation "OFF" and unplug
the power plug.
(Continued)
[Otherwise, electric shock or injury may be caused]
Once every two weeks
Remove the
● For heavy dust E - 25
dust with a
● Do not apply too much force on
vacuum
the filter.
cleaner (Otherwise, the filter may be
damaged.)
Once a week
Dispose
● Remove the lid slowly from the corner.
water and
take the tank
lid off
● Wash the tank with dishwashing
Wash the
sponge.
inside of the
● Use mild detergent (dishwashing
tank
soap) with lukewarm water if
necessary.
● Check to see if the float is
Dry the tank
securely attached.
with a soft cloth
● If the float comes off: E - 30
● Take care not to damage the float.
Put the tank
● Be sure to tightly close the tank
lid. (Otherwise, water may leak.)
lid on
We recommend periodical cleaning for
a long, clean and sanitary use! Diligent
maintenance is also necessary for
releasing of steady and high
concentration Plasmacluster ions.
FOR HEAVY DUST / WHEN ODOR IS A CONCERN
to wipe
● Do not wash with water
1 Remove the rear panel and the filters.
2 Remove dirt on the sensor as shown in
the figure above with a cleaner.
3 Install the rear panel back to the product.
WHEN NOT USING FOR A LONG PERIOD OF TIME
1
Beep
Conduct internal
drying operation
E - 22
Vacuum
cleaner
2
Dispose tank water and clean
the main unit
E - 22~25
● For heavy dust, soak a soft cloth in lukewarm
water (40°C or lower) or mild detergent to wipe
dirt off.
● Clean the casters, too.
Rear panel
Soaking time: about 10 minutes
1 Soak and wash with
synthetic kitchen
detergent.
2 Gently scrub with a
toothbrush and fully wash so that there
would not be detergent residual left.
3 Dry in the shade.
Plastic bag
3
Store in a dry place with
no direct sunlight
E - 25