Table of Contents
Related Manuals for Petsafe Little Dog PDT00-13623
Summary of Contents for Petsafe Little Dog PDT00-13623
-
Page 1: Operating And Training Guide
Elite Remote Trainers operating and training guide Little Dog Model number PDt00-13623 Big Dog Model number PDt00-13625 Little Dog ADD-A-Dog Big Dog ADD-A-Dog ® ® PAC00-13631 PAC00-13632 PLeAse reAD this entire guiDe Before Beginning... - Page 2 Important Safety Information Explanation of Attention Words and Symbols used in this guide This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
- Page 3 It is important to continue daily checks of the contact area. If redness or sores are found, discontinue use until the skin has fully healed. PetSafe Remote Trainers must be used only on healthy dogs. We recommend that you take ®...
-
Page 4: Table Of Contents
Our products and training tools enhance the relationship between pets and their owners. If you have any questions about our products or training your pet, please visit our website at www.petsafe.net or contact our Customer Care Center at 1-800-732-2677. -
Page 5: Components
: Every Elite Remote Training system is 2-dog compatible : Rechargeable batteries in both the Handheld Remote and Receiver Collar : Waterproof Handheld Remote and Receiver Collar Other Items You May Need : Scissors : Lighter : Non-metallic collar and 10-foot leash www.petsafe.net... -
Page 6: How The System Works
1000 yards. At the push of a button, your remote sends a signal activating your dog’s Receiver Collar. He receives a safe but annoying stimulation. He’ll quickly learn the association between his behavior and your correction; in no time, you’ll have a better-behaved pet. The PetSafe Elite Remote ®... - Page 7 Note: When a Continuous Stimulation button is held for 10 seconds or more, the Handheld Remote will “time-out.” The button will need to be released and pressed again before additional Stimulation can be delivered. The Elite Remote Training systems will never exceed a Stimulation Level above High-15. Wrist Strap Clip www.petsafe.net...
- Page 8 Receiver Collar: Delivers stimulation or tone on a signal from the Handheld Remote. All Elite Trainers are waterproof. On/Off Button: Momentarily pressing and holding this button turns the Receiver Collar on and off. Contact Points: The contacts through which the Receiver Collar delivers Stimulation. Receiver Indicator Light: Indicates when the Receiver Collar has been turned on or off and also serves as a low-battery indicator.
-
Page 9: Operating Guide
Dog 1/ Dog 2 The symbol displayed is the active dog receiver collar. See Two Dog System on page 14. Tone or Stimulation When pressing Tone or Stimulation the Dog 1 or Dog 2 symbol will appear in bold or emphasized. www.petsafe.net... - Page 10 Tone Only When pressing Tone Only for Dog 1 or Dog 2 the number zero appears. Battery Indicator The battery indicator provides constant awareness of your battery’s power level. See Battery Indicator for more detailed information. Note: Factory preset is for Dog 1 mode, you will not see the Dog 2 symbol unless the unit is programmed for Dog 2 (see Two Dog System on page 14).
-
Page 11: Prepare The Receiver Collar
If it does not, see “To Pair the Handheld Remote and the Receiver Collar”. Note: To extend the life of the battery, turn the Receiver Collar off when it is not in use. Little Dog Receiver Collar Big Dog Receiver Collar On/Off Button (On bottom of receiver) On/Off Button www.petsafe.net... - Page 12 To Turn the Receiver Collar Off 1. Press and hold the On/Off button until the Red LED comes on and the Receiver Collar beeps high to low. 2. Release the On/Off button. To extend the life between charging cycles, turn the Receiver Collar off when it is not in use.
-
Page 13: Fit The Receiver Collar
The Receiver Collar should not be worn for more than 12 hours out of every 24-hour period. Leaving the collar on too long could lead to skin irritation. Please refer to page 2 for additional information. www.petsafe.net... -
Page 14: Two Dog System
To Re-Thread the Collar Slide Buckle Ridges : The slide buckle prevents the collar from becoming loose around your pet’s neck. : The ridges must be facing up; the collar will slip if it is not properly threaded. Step 4 Two Dog System Note: If you wish to add another receiver collar to the training system, ADD-A-Dog collars are... -
Page 15: To Pair Dog 1 Receiver Collar And The Handheld Remote
3. The Receiver Collar will beep and the LED will flash. 4. Press the Tone button . 5. The Receiver Collar will respond and pair. 6. If the Receiver Collar does not respond, please contact the Customer Care Center. Note: Pairing is for Dog 1 only. www.petsafe.net... -
Page 16: Training Guide
Training Guide General Tips : Eliminate one misbehavior or teach one obedience command at a time. If you move too fast with training, your pet may become confused. : Be consistent. Correct your pet every time he misbehaves. : Unless you can supervise him, it is recommended that you restrict your pet from situations in which he has a history of misbehaving. -
Page 17: Find The Best Stimulation Level For Your Pet
“Test Light Instructions” section. If after completing all of these steps your dog still does not indicate he is feeling the Stimulation, please contact Customer Care Center or visit our website at www.petsafe.net. +2 Boost A press of this button sends a signal to the collar to issue a correction that is 2 levels higher than the currently selected level. -
Page 18: Teaching Basic Obedience
Teaching Basic Obedience The “Sit” Command 1. Put a separate, non-metallic collar on your pet’s neck ABOVE the Receiver Collar, and attach a 10-foot leash. Note: Be sure the extra collar does not put pressure on the Contact Points. 2. Hold the leash and the Handheld Remote in one hand. Keep your other hand free to guide your pet into a “Sit”... - Page 19 6. Immediately release the Stimulation button as soon as your pet returns to the area and praise him enthusiastically. 7. Once your pet has settled for a few seconds, release him and play calmly. 8. Repeat steps 1 through 6 several times adding some different types of distractions. www.petsafe.net...
-
Page 20: Eliminating Unwanted Behavior
Eliminating Unwanted Behavior Jumping Up Pets typically jump up to get attention. If you do not want your pet to jump on you, then friends or members of the family should not encourage this behavior. That means every time your pet jumps on someone, he should be reprimanded or redirected to an alternate and acceptable behavior, for which he can receive praise. - Page 21 “Recall.” Praise your dog as he comes to you. 5. If your dog ignores the stimulation, repeat using a higher level of stimulation. 6. Repeat the process until your dog responds consistently to the “Recall” command. www.petsafe.net...
-
Page 22: Trash Raiding
Trash Raiding The easiest way to prevent trash raiding is to remove garbage and tempting food from your pet’s environment. You can use the Remote Trainer to teach your pet to stay away from these items; however, you must be prepared to correct your pet every time he approaches them. 1. - Page 23 ® Receiver Collars work with the Elite Remote Training systems. : We do not recommend any of our products to be used Can I use the PetSafe Elite ® Remote Trainers on aggressive on aggressive pets. We recommend you contact your...
-
Page 24: Test Light Instructions
Troubleshooting : Check to see if the Receiver Collar has been turned on. My pet is not responding when I press a button. : If your range has reduced from the first time you have used it, please check to see if the battery is low in either the Handheld Remote or Receiver Collar. -
Page 25: Accessories
Corporation be liable for any direct, indirect, punitive, incidental, ® special or consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product. www.petsafe.net... -
Page 26: Battery Disposal
Customer Care Center to receive instructions on proper disposal of the unit. Please do not dispose of the unit in household or municipal waste. For a listing of Customer Care Center telephone numbers in your area, visit our website at www.petsafe.net. Perchlorate Battery Perchlorate Material –... -
Page 27: Warranty
One Year Non-Transferrable Limited Warranty This Product has the benefit of a limited manufacturer’s warranty. Complete details of the warranty applicable to this Product and its terms can be found at www.petsafe.net and/or are available by contacting your local Customer Care Centre. - Page 28 Should you have any queries or require any further information, please contact our Customer Care Centre on 1800 786 608 (Australia) or 0800 543 054 (New Zealand). Radio Systems Corporation ® 10427 PetSafe Way Knoxville, TN 37932 1-800-732-2677 www.petsafe.net 400-1461/1...
- Page 29 DO NOT PRINT THIS PAGE RSC Part #: 400-1461-1 Description: MANUAL PDT00-13623/13625/PAC00-13631/13632 ROHS Created by: Material: 100gsm Wood Free Initial Creation Date: 10-25-13 Paper Approved by: LTAYLOR Printing: Black Date Approved: 12-2-13 Finishing: Die Cut, Fold, 2 Program used: INDESIGN CS6 Saddle Stitch, and Bulk Pack Revision: ECO:...
Need help?
Do you have a question about the Little Dog PDT00-13623 and is the answer not in the manual?
Questions and answers