Wiring Harness; Without Handle And Carburetor Heating; With Handle Heating System - Stihl MS 341 Shop Manual

14.8

Wiring Harness

14.8.1 Without Handle and
Carburetor Heating
1
– Separate the crankcase from the
tank housing – b 12.9
– Remove the short circuit wire –
b 10.1
– Remove the ground wire – b 7.2
: Pry out the grommet (1).
: Pull out the wires (1).
Install in the reverse sequence.
1
On machines with
QuickStop Super
: Position the wires (arrows) under
the brake cable (1).
100
2
: Make sure the ground wire (1)
and short circuit wire (2) are
correctly positioned (see arrows).
Check correct installed position of
the grommet (arrows).
Install all other parts in the reverse
sequence.
14.8.2 With Handle Heating
System
1
2
2
– Separate the crankcase from the
tank housing – b 12.9
– Remove the short circuit wire –
b 10.1
– Remove the ground wire – b 7.2
– Remove the interlock lever –b
10.2.1 or 10.2.2
: Remove the wire (1) from the
guide (arrow).
: Push back the insulating tubes
(2) and separate the connectors.
: Pull the wires out of the insulating
tube (1).
– Pull the wire out of the opening in
the tank in direction of front
handle.
MS 341, MS 361, MS 361 C
1
1