Nilfisk-ALTO NILFISK ALTO 106269015 Operating Instructions Manual page 12

NEPTUNE PE/DE
5.2 Some typical cleaning tasks
5.2.1 Agriculture
Task
Stables
Pig Pens, Sties
Cleaning of walls,
fl oors and equip-
ment
Disinfectant
Machinery
Tractors
ploughs etc.
5.2.2 Vehicle
Task
Vehicle bodywork
10
Accessories
Chemical Foam Injec-
tors
Foam lance
Powerspeed lance
Floor Cleaner
Detergents
Universal
Alkafoam
Disinfectant
DES 3000
Detergent injection
Powerspeed lances
Curved lances and
underchassis washers
Brushes
Accessories
Standard lance
Detergent injection
Curved lances and
underchassis washers
brushes
Detergents
Active Shampoo
Active Foam
Sapphire
Super Plus
Aktive Wax
Allosil
RimTop
Method
1. Soaking – apply foam to all surfaces (bottom to top)
and wait for approx. 30 minutes.
2. Remove the dirt from surfaces with the high pres-
sure lance or chosen accessory. Again, clean from
bottom to top on vertical surfaces.
3. To fl ush away large quantities of dirt, change to low
pressure mode and use the higher fl ow to push
away the dirt.
4. Use recommended disinfectant products and meth-
ods to ensure hygiene. Apply DES 3000 disinfectant
once the surfaces are perfectly clean.
1. Apply detergent to vehicle or equipment surfaces in
order to soften up dirt and grime. Apply from bottom
to top.
2. Proceed with cleaning using the high pressure
lance. Clean again from bottom to top. Use acces-
sories to clean in diffi cult to reach places.
3. Clean fragile areas such as motors, rubber at lower
pressure levels to avoid damage.
Method
1. Apply detergent to vehicle or equipment surfaces
in order to soften up dirt and grime. Apply from bot-
tom to top. In cases of particularly dirty vehicles,
pre-spray with a product such as Allosil in order to
remove traces of insects etc, then rinse at low pres-
sure and apply normal car cleaning detergent. Let
detergents settle for 5 minutes before cleaning off.
Metallic surfaces can be cleaned using RimTop.
2. Proceed with cleaning using the high pressure
lance. Clean again from bottom to top. Use ac-
cessories to clean in diffi cult to reach places. Use
brushes in order to add a mechanical cleaning ef-
fect. Short lances can help for cleaning of motors
and wheel arches. Curved lances or undercarriage
washers can be valuable for the cleaning of car
underchassis and wheel arches.
3. Clean fragile areas such as motors, rubber at lower
pressure levels to avoid damage.
4. Apply a liquid wax using the pressure washer in
order to protect the bodywork from pollution.