Installation - Zanussi ZSG20100 User Manual

Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

WARNING!
Refer to Safety chapters.
General Information
CAUTION!
Do not block the air vents. If you do
that, the appliance can overheat.
CAUTION!
Do not connect the appliance to
adapters or extension leads. This
can cause overloading and risk of
fire.
CAUTION!
The minimum installation height is
85 cm.
• The microwave is for built-in use only. It must
be placed on a stable and flat surface.
• The cabinet can not have a back wall in the
place where the microwave is located.
• Put the microwave far away from steam, hot
air and water splashes.
• If the microwave is to close to the TV and
radio it may cause interference in the
received signal.
• If you transport the microwave in cold
weather, do not activate it immediately after
the installation. Let is stand in the room
temperature and absorb the heat.
Electrical installation
WARNING!
Only a qualified person must do the
electrical installation.
The manufacturer is not responsible
if you do not follow the safety
precautions from the chapter "Safety
Information".
www.zanussi.com
We recommend that you write the data here:
........................................
........................................
........................................
This microwave is supplied with a main cable
and main plug.
The cable has an earth wire with an earthing
plug. The plug must be plugged into an outlet
that is properly installed and earthed. In the
event of an electrical short circuit, earthing
reduces the risk of electric shock.
Installing the microwave
1. Check if the dimensions of the furniture
meet the installation distances.
D
A
B
Installation distances
Dimension
A
B
C
D
2. If the cabinet depth is over 300 mm, put the
template on the bottom of cabinet and
check if it fits. If yes, mark the spots for
C
mm
380 + 2
560 + 8
340
18
25