Installation - Zanussi ME905 Use & Care Manual

Installation
Please note: This microwave cooker has
been designed to be used in a domestic
household. Therefore the guarantee
supplied with this appliance may be
invalidated if it has been used for a
commercial or catering application. After
unpacking, ensure that all packing
materials have been removed from the
oven cavity.
Positioning
This oven is free-standing and can be
placed wherever you choose within reach
of a power outlet. Ensure that the surface
on which the oven is to stand is level and
is capable of withstanding the weight. To
ensure that the oven has adequate
ventilation, there must be at least 2.5cm/l
inch of clearance at the top, 4cm/1'/2
inches at the back and a total of 15cm/6
inches side clearance.
The unit must not be installed in any area
where heat and steam are generated, for
example, next to a conventional oven.
NOTE: Do not store cookbooks or the
instruction book inside or underneath the
oven. Do not place tea towels or utensils
over the cooling vents.
Electrical Connection
★ THIS APPLIANCE MUST BE
EARTHED
For your convenience and safety, your
new Zanussi microwave oven comes ready
fitted with a moulded flex and plug. All
you need to do is push the plug into a 13
amp power socket and switch on. If for
any reason you need to replace this plug
with one of your own, you will find the
wires inside the flex are colour coded as
follows:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug. If this is the case proceed as
follows:
Connect the green and yellow (earth) wire
to the terminal in the plug which is
marked with the letter 'E' or the earth
symbol 4" or coloured either green or
green and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter 'N' or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
'L' or coloured red.
The cut off plug should be disposed of to
avoid the risk of shock from the plug
being inserted into a 13 amp socket
elsewhere in the house.
Fuses
The appliance's moulded-on plug is
supplied fitted with a 13 amp BS1362
fuse. If this fuse blows you can replace it
in the following way:
Remove the plug from the power socket
and use a small screwdriver to lever out
the red plastic fuse carrier located
between the plug's prongs, together with
the old fuse. Fit in a new 13 amp fuse and
clip it back into the plug. Make sure your
new fuse is 'ASTA' approved and
complies with BS1362. If the carrier is
damaged you can get a new one from your
local Zanussi Service Agent, the details of
which can be obtained by looking under
'Z' in your telephone directory.
The plug must not be used without the fusi
cover fitted.
Safety
★ Check that the supply flex and any
other wiring is positioned in such a way
that when the microwave oven is
operating its temperature at any point is
less than 50 degrees C above the ambient
temperature of the room.
2