Installation - Zanussi ME965 Instructions For The Use & Care

Installation
Please note: This microwave cooker has
been designed to be used in a domestic
household. Therefore the guarantee
supplied with this appliance may be
invalidated if it has been used for a
commercial or catering application.
After unpacking, ensure that all packing
materials have been removed from the
oven cavity.
Positioning
This oven is free-standing and can be
placed wherever you choose within reach
of a power outlet. Ensure that the surface
on which the oven is to stand is level and is
capable of withstanding the weight. To
ensure that the oven has adequate
ventilation, there must be at least 2.5cm/l
inch of clearance at the top, 4cm/lV2
inches at the back and a total of 15cm/6
inches side clearance.
The unit must not be installed in any area
where heat and steam are generated, for
example, next to a conventional oven.
NOTE* Do not store cookbooks or the
instruction book inside or underneath the
oven. Do not place tea towels or utensils
over the cooling vents.
Electrical Connection
*THIS APPLIANCE MUST BE
EARTHED
For your convenience and safety, your
new Zanussi microwave oven comes ready
fitted with a moulded flex and plug. All you
need to do is push the plug into a 13 amp
power socket and switch on. If for any
reason you need to replace this plug with
one of your own, you will find the wires
inside the flex are colour coded as follows:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
If you fit your own plug, the colours of the
wires in the mains lead of your appliance
may not correspond with the markings
identifying the terminals in your plug. If
this is the case proceed as follows:
Connect the green and yellow (earth) wire
to the terminal in the plug which is marked
with the letter 'E' or the earth symbol j_
or coloured either green or green and "
yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter 'N' or coloured black. Connect
the brown (live) wire to the terminal which
is marked with the letter 'L' or coloured
red.
The cut off plug should be disposed of to
avoid the risk of shock from the plug being
inserted into a 13 amp socket elsewhere in
the house.
Fuses
The appliance's moulded-on plug is
supplied fitted with a 13 amp BS1362 fuse.
If this fuse blows you can replace it in the
following way:
Remove the plug from the power socket
and use a small screwdriver to lever out
the red plastic fuse carrier located
between the plug's prongs, together with
the old fuse. Fit in a new 13 amp fuse and
clip it back into the plug. Make sure your
new fuse is 'ASTA' approved and
complies with BS1362. If the carrier is
damaged you can get a new one from your
local Zanussi Service Agent, the details of
which can be obtained by looking under 'Z'
in your telephone directory.
Safety
★ Check that the supply flex and any
other wiring is positioned in such a way
that when the microwave oven is
operating its temperature at any point is
less than 50 degrees C above the ambient
temperature of the room.
3