Installation - Zanussi MW 1132 Instructions For The Use And Care

Installation
Positioning
This oven is free-standing and can be placed
wherever you choose within reach of a
power outlet. Ensure the surface is level
and that the oven has adequate ventilation.
There must be at least 2.5 cm/1 inch of
clearance at the top, 4 cm/U
/2
inches at the
back and a total of 15 cm/6 inches side
clearance.
NOTE: Do not store cookbooks or this
instruction book inside or underneath the
oven.
Electrical Connection
For your convenience and safety your new
Zanussi microwave comes ready fitted with
a moulded flex and plug. All you have to do
is push the plug into a 13 amp power socket
and switch on. However, if for some reason
you need to replace this plug with one of
your own, you will find the wires inside the
flex are colour coded as follows:
GREEN AND YELLOW - EARTH
BLUE -NEUTRAL
BROWN -LIVE
If you fit your own plug, the colours of the
wires in the mains lead of your appliance
may not correspond with the markings
identifying the terminals in your plug, this
is what you have to do:
Connect the green and yellow (earth) wire
to the terminal in the plug which is marked
with the letter «E» or the earth symbol ,
or coloured green, or green and yellow.
Connect the blue (neutral wire to the
terminal in the plug which is marked with
the letter «N» or coloured black. Connect
the brown (live) wire to the terminal which
is marked with the letter «L» or coloured
red.
Fuses
The appliance's moulded on plug is supplied
fitted with a 13 amp BS1362 fuse. If this
fuse blows you can replace it in the
following way:
- Remove the plug from the power socket
and use a small screwdriver to lever out the
red plastic fuse carrier located between the
plug's prongs, together with the old fuse.
Fit it with a new 13 amp fuse and clip it
back into the plug. Make sure your new
fuse is ASTA' approved. If the carrier is
damaged you can get a new one from your
local Zanussi Service Agent.
Safety
The manufacturer declines to accept any
liability should these safety measures not
be observed;
• Check that the supply flex and any other
wiring is positioned in such a way that
when the microwave oven is operating its
temperature at any point is less than
50 degrees C above the ambient
temperature of the room.
• Never remove the rear panel of the oven
to gain access to the terminal board. If an
extension is required it should be made
using the standardised plug and the
external cable and it should be capable of
carrying the expected load.
• Check that the fuse and domestic
installation are suitable to carry the electric
load of this appliance (see rating plate at
the back of the oven).
• Check the appliance is properly earthed
according to existing rules and regulations.
• The appliance meets the requirements
laid down in EEC Directive No. 76/889 and
amendment 82/499 relating to the
suppression of radio and TV interference.
IMPORTANT: UNDER NO
CIRCUMSTANCES SHOULD ANY
SERVICE REPAIR WORK BE
CARRIED OUT ON THIS APPLIANCE
BY UNQUALIFIED PERSONS.
5