Download Print this page

Advertisement

Operating and installation instructions
Plate warming drawer
EGW 3060-10
en - GB
To avoid the risk of accidents or
damage to the appliance it is
essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 07 241 630

Advertisement

   Also See for Miele EGW 3060-10

   Summary of Contents for Miele EGW 3060-10

  • Page 1

    Operating and installation instructions Plate warming drawer EGW 3060-10 en - GB To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time.

  • Page 2: Table Of Contents

    Contents Guide to the appliance ..........3 Warning and Safety instructions .

  • Page 3: Guide To The Appliance

    Guide to the appliance a On/Off switch (lights up) b Temperature control c Warming drawer d Anti-slip mat e In-operation indicator f Warning sticker (Caution: Danger of burning on the heating element)

  • Page 4: Warning And Safety Instructions

    Keep these instructions in a safe these operating and installation place and ensure that all users are instructions. Miele cannot be held liable familiar with the contents. Pass them for damage resulting from incorrect or on to any future owner of the improper use or operation.

  • Page 5

    Miele cannot be held liable for the The appliance gets hot when in use consequences of an inadequate and remains hot for quite a while after earthing system (e.g.

  • Page 6

    H 05 V V-F cockroaches or other vermin, pay (pvc insulated), available from the Miele particular attention to keeping the Spare Parts Department. appliance and its surroundings in a Faulty components must only be clean condition at all times.

  • Page 7

    Do not use the appliance to re-heat, cook or keep food or drinks warm, as Miele cannot be held liable for moisture in the food or drinks could cause corrosion damage to the drawer. damage caused by non-compliance...

  • Page 8: Caring For The Environment

    Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.

  • Page 9: Before Using For The First Time

    Before using for the first time Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service" section of this booklet. Cleaning and heating up for the first time ^ Remove any protective foil and sticky labels.

  • Page 10: Operation

    Operation Do not use the appliance to re-heat, cook or keep food or drinks warm. Condensation from the food or drinks could lead to corrosion in the appliance. Always use oven gloves to remove heated crockery from the drawer. The load bearing capacity of the appliance is 15 kg maximum.

  • Page 11: Operation

    Operation Operation ^ Place the crockery inside the drawer. ^ Select the temperature required. ^ Switch on the appliance (j). The switch lights up. ^ Close the drawer. Switch the appliance off (k) before removing the heated crockery. Pull the drawer out to its full extent before unloading it. Selecting a temperature The temperature dial allows you to select any temperature between approx.

  • Page 12: Heating Up Times

    Operation Heating up times Various factors will affect the heating up times: – The material and thickness of the crockery – Maximum capacity – How the crockery is arranged – The temperature setting. It is therefore not possible to state precise times. However, the following information can be used as a guide: At a temperature setting of approx.

  • Page 13: Capacity

    Operation Capacity The quantity that can be loaded will depend to a great extent on the type and size of your own crockery. Example – 25 Cappuccino cups, C 88 mm – 56 Espresso cups, C 60 mm Place cups and glasses upside down in the drawer so that they warm through thoroughly.

  • Page 14: Cleaning And Care

    If not, it might become impossible to remove and could cause the outer surfaces to alter or discolour. Clean the front using a Miele microfibre E-cloth or with a clean sponge and a solution of hot water and washing-up liquid. Then dry with a soft cloth.

  • Page 15: Anti-slip Mat

    Cleaning and care To avoid damaging the surface of your appliance, do not use: – cleaning agents containing soda, ammonia, acids or chlorides, – cleaning agents containing descaling agents, – abrasive cleaning agents, e.g. powder cleaners and cream cleaners, – solvent-based cleaning agents, –...

  • Page 16: Problem Solving Guide

    Problem solving guide Installation work and repairs to electrical appliances must only be carried out by a suitably qualified and competent person in strict accordance with current local and national safety regulations (BS 7671 in the UK). Repairs and other work by unqualified persons could be dangerous.

  • Page 17

    Check whether – the mains fuse has tripped. If any of the following problems occur, please contact the Miele Service Department..The crockery is too hot. The temperature control is faulty..the On/Off switch does not light up when the appliance is switched on.

  • Page 18: Optional Accessories

    Optional accessories These can be ordered via the internet at www.miele-shop.com, or from the Miele Customer Contact Centre (see back cover for contact details) or from your Miele dealer. Anti-slip mat Anti-slip mat to keep crockery secure E-Cloth (microfibre cloth)

  • Page 19: Safety Instructions For Installation

    Safety instructions for installation Before connecting the appliance to the mains supply make sure that the connection data on the data plate (voltage and frequency) correspond with the mains electricity supply, otherwise the appliance could be damaged. Consult a qualified electrician if in any doubt. The socket and on-off switch should be easily accessible after the appliance has been built in.

  • Page 20: Building-in Dimensions

    Building-in dimensions Possible combinations Coffee machine Steam oven * Appliances with glass front ** Appliances with metal front...

  • Page 21: Installing The Appliance

    Installing the appliance ^ Push the appliance into the housing unit as far as the vapour strip and align it. Ensure that the housing unit is aligned at a right angle. ^ Open the drawer, and use the 2 screws supplied to secure the appliance to the side walls of the housing unit.

  • Page 22: Aligning The Front Of The Plate Warmer

    Aligning the front of the plate warmer After building in the combination appliance, it may be necessary under certain circumstances to – align the front of the plate warmer – align the gap between the plate warmer and the combination appliance. To help you do this, there are adjusting points underneath the nuts which secure the drawer to the telescopic runners.

  • Page 23: Electrical Connection

    Electrical connection All electrical work should be carried out by a suitably qualified and competent person, in strict accordance with current local and national safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.

  • Page 24

    Electrical connection Important U.K. This appliance is supplied for connection to a single phase 230-240 V 50 Hz supply with a 3-core cable. The wires in the mains lead are coloured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live WARNING: THIS APPLIANCE MUST BE...

  • Page 25: After Sales Service, Data Plate

    Please note that telephone calls may be monitored and recorded to improve our service. When contacting Miele, please quote the model and serial number of your appliance, which are given on the data plate. N.B. A call-out charge will be applied for unnecessary service visits where the problem could have been resolved as described in these instructions.

  • Page 28

    Alteration rights reserved/ 2710 M.-Nr. 07 241 630 / 02...

Comments to this Manuals

Symbols: 0
Latest comments: