C&K systems SYS3316RF Installation Instructions Manual page 25

Program Option Program Option Program Option Program Option Program Option
Audible/Visual Switches
Unit Control
Loop Switches
Loop Switches
CL CL CL CL CL Program Function Program Function Program Function Program Function Program Function
2E (1 & 2) Entry/Exit
Pre-Alarm
2F (3) Enable 4-minute
Power-Up
Delay
30 - 3F (3) Allow Group
Shunting
30 - 3F (4) Delay Before Dial
Comments Comments Comments Comments Comments
If Digit Postition (1) is programmed for Entry Pre-Alarm, the
keypad will sound continuously for all but the last 10 seconds of
the amount of time programmed for the Entry Delay Time (CL 2D
(3)). The keypad will beep for the last 10 seconds of the Entry
Delay. If Digit Position (2) is programmed for Exit Pre-Alarm, the
keypad will beep for the time programmed into CL 2D (4), Exit
Delay Time. The speed at which the keypad beeps will increase
during the last 10 seconds of the Delay time. Alpha II keypads
will display a bar graph in addition to the audible tone.
Suppresses all trouble and alarm reports for a period of four
minutes after power is initially applied to the panel. This allows
the sensors, such as PIR's time to stabilize when initializing or
prevents powered devices, such as smoke detectors, from
sending alarms when first starting panel with a dead battery or no
battery connected.
This allows multiple loops to be shunted simultaneously with a
single keypad command. This is typically done on all interior
loops in a system. The command also Arms or Instant Arms the
system. (See page 21 for Group Bypassing and Instant Arm.)
This option programs the loops to have a delay after they are
triggered to allow the User time to shut down the system in the
event of an accidental triggering of the zone. The amount of time
is determined by the value programmed into CL 0B Digit Position
(1). The time delay may be between 10 and 150 seconds, in 10
second intervals.
25 25 25 25 25
SYS3316RF Installation Manual