C&K systems SYS3316RF Installation Instructions Manual

SYS3316RF Installation Instructions SYS3316RF Installation Instructions
SYS3316RF Installation Instructions
SYS3316RF Installation Instructions SYS3316RF Installation Instructions
BATTERY BATTERY BATTERY
BATTERY BATTERY
RED RED
RED RED RED
16.5 VAC
25 - 40 VA
50-60 Hz
AUDIBLE
10.5-13.5 VDC
SWITCHED
UNSWITCHED
Protected by Fuse
AUX POWER
F1: 3AG, 2.5 A AUX POWER
10 - 12 VDC Protected by Fuse
Fuse F4 3 AG,
Protected by
F2: 3 AG, 0.75 A
3 A battery
Fuse F2: Shared with keypads
protection
3 AG, 0.75 A
and AUX Power
WARNINGS: WARNINGS:
WARNINGS: WARNINGS: WARNINGS:
For continued protection For continued protection For continued protection For continued protection For continued protection
against risk of fire, against risk of fire,
against risk of fire, against risk of fire, against risk of fire,
replace fuses only with replace fuses only with replace fuses only with replace fuses only with replace fuses only with
Capacity for Capacity for Capacity for Capacity for Capacity for
fuses of same type and fuses of same type and
fuses of same type and fuses of same type and fuses of same type and
emergency emergency emergency
emergency emergency
BLK BLK BLK BLK BLK
rating rating rating rating rating
standby at standby at standby at standby at standby at
least 4 hours least 4 hours least 4 hours least 4 hours least 4 hours
KEYPAD INFORMATION
Do not exceed 4 keypads
or max AUX POWER
Protected by Fuse F3:
3 AG, 0.75 A
U6 U6 U6 U6 U6
U14 U14 U14 U14 U14
DS1 DS1
DS1 DS1 DS1
WATCH
DOG
PHONE CORDS PHONE CORDS PHONE CORDS
PHONE CORDS PHONE CORDS
Use either:
- 9.X PCF
- 9.X PCP
GENERAL INFORMATION GENERAL INFORMATION GENERAL INFORMATION GENERAL INFORMATION GENERAL INFORMATION
- Connect ground wire from door hinge to earth ground using
16 AWG, green jacketed, solid-conductor wire
- All outputs are power limited
- If programmed for EOL or Supervised loop, the 2.2K ohm EOL
resistor (Model 9.X, 2.2K) must be at end of circuit
- SN913-I/O card requires 2.2 K ohm resistor (P/N 5-162-024-00)
- Loop 8 can be used as standard loop or used for switched 10-
12.5 VDC at 50 mA for 2-wire powered devices. Loop 8 can
support up to 10 BRK Model 2400 2-wire smoke detectors.
- Loop voltages:
Loop 7
0 - 2 VDC = short
2 - 3 VDC = normal
3 - 5 VDC = open
- are electrically common
Red = incoming ring
Green = incoming tip
Gray = seized ring
Brown = seized tip
Blue = tamper
Orange = tamper
Loop 8
0 - 2.5 VDC = short
2.5 - 8.5 VDC =
normal
8.5 - 15 VDC = open
P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A P/N 5-051-396-00 Rev A