Conference Call Between Three Participants - Siemens GIGASET SX762 WLAN DSL Manual

Key combination
R2
R0
R1

Conference call between three participants

Key combination
R3
R2
R4
Effect
Accept call waiting/
toggle between two
calls
Reject call waiting
Terminate one call
and return to the
waiting call
Effect
Conference call
End the conference
call and continue
calls separately
End conference call
and set up the con-
nection between call
parties
End conference call
Description
Press R2 to accept an incoming call
during a call. The connection to the
first call is put on hold.
If you terminate the first call before-
hand, your phone rings and you can
take the second call as usual.
By pressing R2 again, you can toggle
to the waiting caller.
Press R0 to reject an incoming call
during a call.
The second call is rejected automati-
cally after 120 seconds have elapsed.
Press R1 to end the current call. You
then switch to the waiting call. The
second call is ended automatically
when you replace the receiver.
Description
When you are making a call and a sec-
ond call is waiting (see above), press
R3 to enable a conference call
between you and the two call parties.
Press R2 to end the conference call.
You are then connected to the previ-
ously active call again and the previ-
ous waiting call is now in the wait
state again.
If you press R4 during a conference
call, you end your call and set up a
connection between the other two
external call parties. You can then
replace the receiver. In the case of an
internal conference call, you simply
need to hang up.
Replace the receiver to terminate all
calls.
Call guide
91