System Board; Removing The System Board - Dell PowerEdge FC830 Owner's Manual
Hide thumbs
Also See for PowerEdge FC830:
- Owner's manual (154 pages) ,
- Getting started with your system (2 pages) ,
- Owner's manual (150 pages)
Table of Contents
Advertisement
Figure 40. Replacing the NVRAM backup battery
1.
negative side of battery connector
Next steps
1.
If applicable, install the memory module.
2.
Install the following:
a.
hard drive/SSD cage
b.
hard drive/SSD backplane
c.
hard drive/SSD
3.
Follow the procedure listed in
4.
Enter System Setup to confirm that the battery is operating properly.
5.
Enter the correct time and date in the System Setup's Time and Date fields.
6.
Exit System Setup.
7.
To test the newly installed battery, remove the sled for at least an hour.
8.
Reinstall the sled after an hour.
9.
Enter System Setup and if the time and date are still incorrect, see
System board
Removing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
108
After working inside your
2.
positive side of battery
system.
Getting
Help.
Advertisement
Table of Contents
Troubleshooting
